[davemonfl]

Hi all,

Trying to code $644 into VO in CAS and NFRM using NCS Expert. I have successfully added $644 to both CAS and NFRM and done an FA_WRITE but when I try SG_CODIEREN to reset the 2URAD ECU I get an error in German:

[davemonfl]

Originally Posted by davemonfl

Hi all,

Trying to code $644 into VO in CAS and NFRM using tutorial below. Does this look complete? Some other tutorials refer to saving TRC and MAN, but the one I'm following does not. I have successfully added $644 to both CAS and NFRM but when I try SG_CODIEREN to reset the 2URAD ECU I get an error in German...

So I read in another coding forum that if you are going to code 2urad you need an Icom because its a MOST module. Then another user said I should be able to do it with my KCAN DCAN cable by adding $644 to the 2URAD VO and the MULF2 VO. Has anyone heard of this work around before?

[Joe@TopGearSolutions]

Originally Posted by davemonfl

So I read in another coding forum that if you are going to code 2urad you need an Icom because its a MOST module. Then another user said I should be able to do it with my KCAN DCAN cable by adding $644 to the 2URAD VO and the MULF2 VO. Has anyone heard of this work around before?

For your situation, you will need an ICOM due to it being on the MOST loop. The only modules in the car that "stores" the VO are CAS and FRM. You can't do a FA_WRITE to other modules.

[CrackedatBMW]

Originally Posted by Joe@TopGearSolutions

For your situation, you will need an ICOM due to it being on the MOST loop. The only modules in the car that "stores" the VO are CAS and FRM. You can't do a FA_WRITE to other modules.

Hello i have added $644 TO MY VO BUT i don't see the mulf module



Please help