[CrackedatBMW]

Hi, I have had a CIC installed for a few days now. I have adjusted the Vo/FA and added the following codes
$609
$6VA
$697
Now a number of problems appear
1, I get a message on my dashboard (see photo 1)
2, when I read my car with ista, it still shows ccc ant & ccc/ask in red. How is this possible?
3,I used inpa to take a look and then I didn't see cic but CCC? (see photo 3)
4, I now also see that the tel/mulf + cid is not written to my vin. When I use ncs expert I also see no tel/mulf between my ecu list


I'm wondering this so I thought I'd make a post on bimmerpost thanks in advance

[BRG_N54]

There is more to coding a CIC than just those items you listed. I suggest you follow this guide, I used it to do two cars with 100% success.

[CrackedatBMW]

Originally Posted by BRG_N54

There is more to coding a CIC than just those items you listed. I suggest you follow this guide, I used it to do two cars with 100% success.

hello thanks for your answer but i dit evrything.. + i followt a youtube video about it (BMW DIY) i also tried to delete the 609 but then i cannot acces my cic ect

[BRG_N54]

Originally Posted by CrackedatBMW

hello thanks for your answer but i dit evrything.. + i followt a youtube video about it (BMW DIY) i also tried to delete the 609 but then i cannot acces my cic ect

Again, if you follow the steps in that guide, specifically the second post in grey, it is everything you need to get it working. It is a lot of very complex steps that must be done in a very specific order for it to work. If you are not having success, perhaps it's time to throw in the towel and look into someone who can do the coding part remotely?

[CrackedatBMW]

Originally Posted by BRG_N54

Again, if you follow the steps in that guide, specifically the second post in grey, it is everything you need to get it working. It is a lot of very complex steps that must be done in a very specific order for it to work. If you are not having success, perhaps it's time to throw in the towel and look into someone who can do the coding part remotely?

i said that i did that

1, i edited the VO/Fa after that i write it in cas+frm(NFRM)
2, after that i press procec ecu (CIC) then click on SG_codieren
3, write the vin into the cic
4, then the navagation thing i already did that to + its worked