|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
IDrive infotainment system controller not responding.
|
|
07-30-2024, 05:00 PM | #1 |
Registered
0
Rep 4
Posts |
IDrive infotainment system controller not responding.
The infotainment system controller is not responding but the screen still works and is not frosen would this be the controller, a fuse? That is the type of controller I am using my model will be below with a lot of other knowledge I know about the car.
2011 328i XDrive N52 AWD trans: steptronic |
08-02-2024, 09:32 AM | #2 |
New Member
5
Rep 8
Posts |
These controllers are known for going bad, but mostly on Pre-LCI models, not models fitted with CIC (like yours).
Before you get a new one, check the fuse box that is located behind your glovebox. There is a fuse diagram in there as well. When checking fuses use a multimeter, not just visual checking. If fuses are OK, then check the controller wiring to make sure its getting +12V and GND. There are 4 wires in total and the other two are CAN wires. If its getting voltage and ground, then you have 2 possible issues - either the controller itself is faulty, or the CAN wires are faulty. My money is on the controller itself though |
Appreciate
0
|
Yesterday, 06:43 AM | #4 |
Registered
0
Rep 4
Posts |
If it is the controller would one work from a wrecked e90 or do vins have to match and is there anything to prevent water damage because I think someone spilled something and didn’t tell me and that’s why it it’s not working not trying to go threw this again because of careless people
|
Appreciate
0
|
Bookmarks |
|
|