[Nevin57]

Hello everyone recently I brought my car back out in hopes to get it going needed a steering angle sensor and new dsc module so I got those both replaced and encoded and everything was fine, put my winter tires on and was going to run it in for an alignment and it didn't want to start so after replacing my starter that went up in smoke I put it back together and again cranks but wont start and the only new code that came up was for starter operation so I've been plugging away trying to diagnose this no start so far I've tested fuel pressure at 73 psi tested all coils and plugs I have good spark on all 6, I did a compression test and I do have 3 holes that are all of a sudden low ones at 90 so I pumped so oil down the hole to see if that helped with no success I can visually see the injectors spray when enabling the with the scanner tonight I pulled the valve cover to check the cams and both qr codes come up to the top with #1 tdc... but when viewing the vanos solenoids with ista it's showing my exhaust vanos state at -114.25 degrees and intake at 120? Is there something I'm missing here I'm leaning towards a faulty cam position sensor but what are the odds of them both failing instantly like that as i had the car running in the garage shut it off and it just never started again? Any help is appreciated i attached a few pictures aswell