[issabmw]

I created a thread not long ago about quad exhausts, but no success. Exhaust shops in area are amateur and refuse to cut stainless steel.

I need someone who can do whats in the first picture. Or simply get a muffler shop that does clean work in your area to do this.

Basically I have cyba tips, like whats in the second picture (except mine are double walled) with the opening in the same reigon. I need the back of the tips capped off and a new hole made on the left side of the passengers side tip and hole made on the right side of the drivers side tip, then have them connected and welded toghether with a straight pipe, then have hangers welded to them for the two rubbers in the non-335i.

Simply the piece should look like this finished:


\ /_________________ \ /


Reason for doing this is to create a custom setup after someone has done this for me, as I can weld, yet I cannot cut stainless steel and do not have piping at the moment.

I will give ALL MEASUREMENTS along with a layout sheet/poster and all neccessary instructions.

Will give $200 aside from labor cost for a clean job.

PM me. Thanks.

[issabmw]

Bump