[jafza412]

I installed Umnitza P90s recently and I noticed on the wiring harness there were four sets of leads:

1. Turn Signal/Parking (1 in picture below)
2. Low Beam (3)
3. High Beam/DRL (5)
4. Extra (12) - A wire coupled with ground into a plastic connector; possibly for AEs?

I didn't think anything of it until I fired up the car and saw an error message with the light bulb (NOT the low beam error that you typically get with a xenon install requiring error cancelers to fix; I had this too but fixed with the ECs). I held in the OBC button and saw error code CC-ID 131/132, which I referenced to my error code cipher and found the errors to be:

131: "Parking light front left, failure!"
132: "Parking light front right, failure!"

What I think is happening is that since that lead is unconnected, the car things there is a bulb missing or fused. Has anyone had this issue before? Could I complete that connection with a resistor? If so, how much resistance would I need?

Thanks in advance!