|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
How to maximize the life of our tuned N54 engines
|
|
11-01-2010, 01:39 AM | #67 |
Banned
149
Rep 2,014
Posts |
Well, it is harder for the oil pump to move a cold thick "liquid" than a warm thin liquid. Just because the oil pump is pushing hard doesn't mean oil is getting where it needs to be in a really cold engine.
|
Appreciate
0
|
11-01-2010, 01:57 AM | #68 |
247
Rep 2,781
Posts
Drives: E90 335i Racecar
Join Date: Jan 2010
Location: San Diego, CA
|
Don't touch it.
__________________
HG Motorsports | Motiv Motorsport | Sparta Evolution | BBS Motorsports | Sabelt | JRZ | NASA ST1 SoCal --- 554whp/487wtrq --- 3200lbs <<YouTube Channel w/ Race Videos>> |
Appreciate
0
|
11-01-2010, 08:58 AM | #69 | |
Captain
51
Rep 966
Posts |
Quote:
Viscosity of engine oil changes with temperature so it will do its job better once it gets to normal operating temps. If you rev your engine high or put excessive load when cold you are working your pistons/cylinders (and turbochargers) hard with thicker, less lubricant oil. Not good if you’re trying to prevent wear. Seems like there is some question about how best to achieve this; warm up by idling or driving gingerly straight away. Personally, I start the car and wait for the RPM to drop from ~1k to ~600 then drive it easy (don’t rev over 2.5-3k rpm) until oil temp hits 190. Cooling down a turbocharged engine prevents coking of the oil. This happens when the oil is overheated by the turbochargers and it doesn’t have a chance to cycle through the rest of the system to return back to normal temp. Our cars have an electric pump that continues to circulate water to cool hot oil after you shut the car off to prevent this, but it’s just good practice to not be at max boost within a few minutes of shutting the car off. Last edited by alextremo; 11-01-2010 at 09:59 AM.. |
|
Appreciate
0
|
11-01-2010, 09:40 AM | #70 |
Banned
549
Rep 2,821
Posts
Drives: X5M F85
Join Date: Aug 2008
Location: SI NY
|
3rd party warranty.. like 4k.
|
Appreciate
0
|
11-01-2010, 09:47 AM | #71 | |
Colonel
264
Rep 2,563
Posts |
Quote:
Alpina_B3_Lux
__________________
Audi R8 LMX, BMW M550i xDrive (G30 LCI); gone: Alpina B3 3,3 (E46), BMW 335i, Audi R8 V10 manual, Audi R8 V10, BMW M235i, BMW 550i F10
|
|
Appreciate
0
|
11-01-2010, 10:00 AM | #72 | |
Captain
51
Rep 966
Posts |
Quote:
Thanks for the correction, updated post. |
|
Appreciate
0
|
11-01-2010, 06:11 PM | #73 | |
Colonel
264
Rep 2,563
Posts |
Quote:
Maybe one could also think of adding (in the modifications list) the possibility of using an upgraded radiator - either a full aluminium one as replacement for the stock piece, as AR Design is offering it, or the additional water cooler from the BMW Performance package (see Mr. 5's thread recently). The latter may however not work with all other mods such as CAI due to space restrictions in the engine bay. Alpina_B3_Lux
__________________
Audi R8 LMX, BMW M550i xDrive (G30 LCI); gone: Alpina B3 3,3 (E46), BMW 335i, Audi R8 V10 manual, Audi R8 V10, BMW M235i, BMW 550i F10
|
|
Appreciate
0
|
11-01-2010, 11:01 PM | #74 |
Captain
121
Rep 892
Posts |
1. You should change your oil every 4k miles if u want your turbos really to last long.
2. Don't boost( stay in vacuum) at all until the oil is about 190F ... 3. When 5mins from your destination don't hit any boost and allow 2 min idle cool down.
__________________
M
|
Appreciate
0
|
11-04-2010, 10:54 AM | #75 | |
Captain
51
Rep 966
Posts |
Quote:
I think these are all covered in the first post (although the timing/frequency may vary slightly) |
|
Appreciate
0
|
Bookmarks |
|
|