[E90Vader]

I'm sure this topic has been beaten to death.. however I can't for the life of me find any numbers particular to the exact mods I'm installing in my car next Tuesday.. so please lend a helping hand and help me out!

I have a 2007 335i Sedan. I'm going to install a Vishnu Procede V5 tune * professional tune & Map * and an AFE Dual CAI

How much BHP and Pounds of torque at the crank should will I respectively have?

How much WHP and Torque at the wheels will I respectively have?

I'm just curious for my own knowledge and what kind of numbers I could expect Ie 0 - 60 and quarter mile times?

It will have a H&R Sport drop and 265 30 R19 rear BF Goodrich G-Force T/A KDW 2 tires.

Thanks so much guys!
I have already spent hours searching the Dyno threads but could not find my specific tune, otherwise I would not post such a thread.

[Rotorocious]

Take the usual gains from the v5 and subtract 1-3 hp with the afe.
I lost power with that filter over stock

[Everling]

put the car on a dyno. hp numbers vary from car to car.

[secretsquirrel]

Just look at any stock + V5 tune to get a ballpark figure.

[Litos]

if you ever get your car on a dyno, i say no more than 305whp and 330wtq.

if you ever get your car at the track, i say no better than a 12.9 or 12.8, depending on launch.

odds are i could be waaaaaay off - this entire thread is nothing but speculation and guessing

[momstmg78]

Between 320 and 340 at back wheels depending on dyno

[E90Vader]

I've figured I'll have around 420bhp on paper at least, however I'm confused as per the torque figures.

Some have said I get around 460 torque just from the tune alone.. Others have said I'll have around 420 430 torque?

Safe to say I'll have about 420bhp and 440 torque or am I drastically under rating the torque number?

[Rotorocious]

Don't think so.
Just do it and find out

[Litos]

Originally Posted by E90Vader

Safe to say I'll have about 420bhp and 440 torque or am I drastically under rating the torque number?

[forza1976]

10000000 torques...

[E90Vader]

This is why I'm asking experts related to how much pounds of torque I'll have at th crank, and break horse power.
I've read many different numbers..

I'm very new to vehicle moding so I have no Idea what to expect.
Some say 460 torque, others say 400, others yet say 420.

Any ball park Idea's?

[cn555ic]

310-320 at most. 420 is full bolt on with meth

[Jeff@TopGearSolutions]

Every dyno is different in its reading. Some Read High Or Low.

~330WHP Give or take 20WHP.

~390WHTQ Give or take 20WHtq


High 12's Low 13's depending on driver and AT or MT. Race Gas or Pump Gas. Etc.

[mke135i]

From Procedetuning.com

"Power gains will vary based upon available octane, additional modifications and conditions. Typical gains on an otherwise stock n54 powered BMW running on 91-93 octane fuel are 70-80 wheel horsepower and 80-90ft-lbs of torque. "


/thread

[Litos]

ok, ok.

WHP = mustang dyno

BHP with tune and intake = 350-360
WHP with tune and intake = 300-320

BTQ with tune and intake = 370-390
WTQ with tune and intake = 340-350