All COBB Tuning AccessPORT Flash for N54 335i Discussion Here

rader1 · 01-24-2012, 12:07 PM

Quote:

Originally Posted by E90SoFlo

Why would they make a Stage1+ when people can just use stage 2?

Some people don't want to install DPs

Brey335i · 01-24-2012, 12:11 PM

Quote:

Originally Posted by E90SoFlo

Why would they make a Stage1+ when people can just use stage 2?

Because people can't use Stage 2 without the supporting mods (DPs).

Stage 1+ is for those who have upgraded to an aftermarket FMIC. I think the one stage that isn't really all that necessary is actually Stage 2. I always recommend FMIC before DP and I don't see why someone would not get an FMIC lol.

E90SoFlo · 01-24-2012, 12:35 PM

Quote:

Originally Posted by Brey335i

Because people can't use Stage 2 without the supporting mods (DPs).

Stage 1+ is for those who have upgraded to an aftermarket FMIC. I think the one stage that isn't really all that necessary is actually Stage 2. I always recommend FMIC before DP and I don't see why someone would not get an FMIC lol.

I have DP's and no FMIC lol

FMIC are stupidly expensive (as are DP's).

RnmEvo9 · 01-24-2012, 12:41 PM

Quote:

Originally Posted by E90SoFlo

I have DP's and no FMIC lol

FMIC are stupidly expensive (as are DP's).

Not if you know where to look. You won't see me spending anywhere near 800 for a set of downpipes. There are also budget FMICs out there that are quite efficient.

ejazbmw · 01-24-2012, 01:11 PM

bump for n55 love

tscdennab · 01-24-2012, 02:25 PM

Quote:

Originally Posted by ejazbmw

bump for n55 love

Unbump.

ontopofm · 01-24-2012, 03:34 PM

I've got these codes
P2AAF - fuel pump plausibilty
P2C7F - Lambda probe after catalytic converter 2, trimming control
P2DED - Power management: quiescent current violation

I'm running stage 2 + fmic drive with 91 oct. Are these codes normal? I'm getting SES permanent light.

enrita · 01-24-2012, 05:38 PM

Quote:

Originally Posted by ontopofm

I've got these codes
P2AAF - fuel pump plausibilty
P2C7F - Lambda probe after catalytic converter 2, trimming control
P2DED - Power management: quiescent current violation

I'm running stage 2 + fmic drive with 91 oct. Are these codes normal? I'm getting SES permanent light.

Delete all codes, reset ECU and drive , if you get them again you definetely have an issue and you should mail cobb for support.

ontopofm · 01-24-2012, 05:44 PM

Quote:

Originally Posted by enrita

Delete all codes, reset ECU and drive , if you get them again you definetely have an issue and you should mail cobb for support.

I've deleted the codes and they popped up again but havent tried to clear the ecu. Already emailed Cobb. Thanks

themyst · 01-24-2012, 05:52 PM

Quote:

Originally Posted by ontopofm

I've got these codes
P2AAF - fuel pump plausibilty
P2C7F - Lambda probe after catalytic converter 2, trimming control
P2DED - Power management: quiescent current violation

I'm running stage 2 + fmic drive with 91 oct. Are these codes normal? I'm getting SES permanent light.

Do u have a BMS dp fix installed? If not one of your rear o2 sensors are toast it seems.

ontopofm · 01-24-2012, 06:04 PM

Quote:

Originally Posted by themyst

Do u have a BMS dp fix installed? If not one of your rear o2 sensors are toast it seems.

No I dont have BMS dps fix. So Cobb AP doesnt fix DPs cell? Why is the O2 toast?

enrita · 01-24-2012, 06:07 PM

Quote:

Originally Posted by ontopofm

No I dont have BMS dps fix. So Cobb AP doesnt fix DPs cell? Why is the O2 toast?

yes it does fix it but your issue is not related to downpipes. you are getting an 02 sensor code . Its an hardware issue.

themyst · 01-24-2012, 06:10 PM

First code is when lpfp can't keep up with req value, no big deal, the second code is because an o2 sensor in the rear isnt doing what it should, and the third code is battery drain related, you likely kept your Cobb ap plugged in for an extended period of time with the car not running. That's as detailed as I can get on a phone.

ontopofm · 01-24-2012, 06:22 PM

Quote:

Originally Posted by enrita

yes it does fix it but your issue is not related to downpipes. you are getting an 02 sensor code . Its an hardware issue.

i didnt get this code before the catless dps installed, so this is imlying that the catless dps killed the O2 sensor?

ontopofm · 01-24-2012, 06:23 PM

Quote:

Originally Posted by themyst

First code is when lpfp can't keep up with req value, no big deal, the second code is because an o2 sensor in the rear isnt doing what it should, and the third code is battery drain related, you likely kept your Cobb ap plugged in for an extended period of time with the car not running. That's as detailed as I can get on a phone.

very informative, thanks themyst

themyst · 01-24-2012, 06:39 PM

Quote:

Originally Posted by ontopofm

i didnt get this code before the catless dps installed, so this is imlying that the catless dps killed the O2 sensor?

It's possible the sensor was damaged during the install or they incorrectly installed the sensor to the wrong downpipe.

enrita · 01-24-2012, 06:48 PM

Quote:

Originally Posted by themyst

It's possible the sensor was damaged during the install or they incorrectly installed the sensor to the wrong downpipe.

+ 1, if this started happening right after dp install there is a huge chance thats the cause. Are you 100 percent sure you are running stage 2? dumb question but you never know :-)

Brey335i · 01-24-2012, 06:56 PM

Quote:

Originally Posted by enrita

+ 1, if this started happening right after dp install there is a huge chance thats the cause. Are you 100 percent sure you are running stage 2? dumb question but you never know :-)

I have the same code. It's a damaged O2 sensor in my case I believe. The downpipes and O2 sensors have been installed like this for months before the code popped up...

ontopofm · 01-24-2012, 07:11 PM

Quote:

Originally Posted by themyst

It's possible the sensor was damaged during the install or they incorrectly installed the sensor to the wrong downpipe.

One of the rear O2 was damaged a few years back when I first got the AR DPs, replaced with spliced Bosch O2 from autozone. Sold the AR DPs a year ago and it has been running up until now. Installed the VRSF DPs and Cobb Stage 2 + FMIC and now getting this code. I marked the sensors when I uninstalled the OEM DPs so they should not have been swapped. I will test the sensor and see what is wrong

Quote:

Originally Posted by enrita

+ 1, if this started happening right after dp install there is a huge chance thats the cause. Are you 100 percent sure you are running stage 2? dumb question but you never know :-)

Read reponse above. Yup I'm running stage 2. Easily verify on Cobb

lawwailok · 01-24-2012, 09:29 PM

bump for any further new update????

Bash · 01-25-2012, 05:27 AM

Quote:

Originally Posted by E90SoFlo

Is there a reason no ST maps for Stage 2?

What ECU version are you?

woptang22 · 01-25-2012, 05:54 AM

Quote:

Originally Posted by COBB Tuning

Thanks for getting an AP! That link is a little outdated as the 2007 models now have full AccessPORT support. You should be able to just plug it in and install without any issues. If we do need to add your ROM, simply follow these instructions on our website. And if you have any other questions, shoot us an email (tech@cobbtuning.com) or call! 866-922-3059

Ian

Thank you Ian, I purchased my AP from **********s. And they were awsome. Alan told me when I receive the AP they will walk me through the process. I know it seems like a simple process, but when it comes to my car I get a bit nervous that Ill mess something up in some way. lol So if I need some help it sounds like Alan will walk me through it. Does that offer also stand through your company? If Im in need of some help could I call and someone walk me through the install? thanks again. John

01-24-2012, 01:11 PM	#3393
ejazbmw blahhh 321 Rep 6,355 Posts Drives: 2014 M235I Join Date: Apr 2007 Location: NJ/NY iTrader: (7)	bump for n55 love
	Appreciate 0 Quote

01-24-2012, 03:34 PM	#3395
ontopofm Lieutenant Colonel 82 Rep 1,548 Posts Drives: stock Join Date: Jun 2007 Location: CA iTrader: (4)	I've got these codes P2AAF - fuel pump plausibilty P2C7F - Lambda probe after catalytic converter 2, trimming control P2DED - Power management: quiescent current violation I'm running stage 2 + fmic drive with 91 oct. Are these codes normal? I'm getting SES permanent light.
	Appreciate 0 Quote

01-24-2012, 06:10 PM	#3401
themyst Major General 192 Rep 6,631 Posts Drives: '16 MK7 GTI Join Date: Feb 2009 Location: NYC iTrader: (8)	First code is when lpfp can't keep up with req value, no big deal, the second code is because an o2 sensor in the rear isnt doing what it should, and the third code is battery drain related, you likely kept your Cobb ap plugged in for an extended period of time with the car not running. That's as detailed as I can get on a phone. __________________ E90 LCI N54 6AT
	Appreciate 0 Quote

01-24-2012, 09:29 PM	#3408
lawwailok Lieutenant Colonel 158 Rep 1,922 Posts Drives: E90 335i, E70 X5 Join Date: Aug 2009 Location: Sacramento, CA iTrader: (18) Garage List 2007 E90 335i [8.00] 2009 E70 xDrive30i [0.00]	bump for any further new update???? __________________ -eric E90 335i TiAg STOCK see my garage for mod list.. E70 X5 SGM try to stay stock :/
	Appreciate 0 Quote