JB4 v28.82 TUNE ONLY Dyno Results

Starscream · 04-08-2015, 10:50 PM

I tried this tune today and for some reason it capped my boost at 9psi when hot and 3psi when the car was cold no matter what map I selected,
Car felt very slow and stock like

I downgraded back to 28.5b and the car went back up to previous boost levels (17/18 with back end flash) and previous higher power

What gives? Did I miss a setting?

335NJ · 04-09-2015, 01:45 AM

Quote:

Originally Posted by Starscream

I tried this tune today and for some reason it capped my boost at 9psi when hot and 3psi when the car was cold no matter what map I selected,
Car felt very slow and stock like

I downgraded back to 28.5b and the car went back up to previous boost levels (17/18 with back end flash) and previous higher power

What gives? Did I miss a setting?

Had the same issue on a buddies car. Was told by Jon@BMS to set all DUTY BIAS in the interface to 0 or 50. After that, car runs like a top.

blisstik · 04-09-2015, 02:24 AM

What does DUTY BIAS actually do at 0 vs 50?

Quote:

Originally Posted by 335NJ

Had the same issue on a buddies car. Was told by Jon@BMS to set all DUTY BIAS in the interface to 0 or 50. After that, car runs like a top.

jayzF30 · 04-09-2015, 07:01 AM

Quote:

Originally Posted by stanlalee

It is basically a flash tune. JB4 is controlling boost. Backend flash timing and fueling. You can get these numbers with or without JB4.

With a JB you need a flash though. Without the JB you just need a flash.

I never understood why anyone would use this map switching to simply lower boost. If you have the octane why not have all the power there all the time and just use your foot to modulate and not go WOT when you don't want to. At least for me if I go WOT I want my full tuning power to be there.

Mike@N54Tuning.com · 04-09-2015, 07:25 AM

Quote:

Originally Posted by Starscream

I tried this tune today and for some reason it capped my boost at 9psi when hot and 3psi when the car was cold no matter what map I selected,
Car felt very slow and stock like

I downgraded back to 28.5b and the car went back up to previous boost levels (17/18 with back end flash) and previous higher power

What gives? Did I miss a setting?

Be sure to read the directions posted with the firmware.

Mike

Jnat · 04-09-2015, 07:55 AM

Quote:

Originally Posted by 335NJ

~$550 in modifications, 2 mods to be precise, and we're looking at 100+ HP & 120 ft/lb over stock. That is truly amazing.

Not a whole lot of platforms that can say a tune and intake gives those numbers.

Agreed!

335NJ · 04-09-2015, 08:37 AM

Quote:

Originally Posted by blisstik

What does DUTY BIAS actually do at 0 vs 50?

I honestly don't know, but it worked. Car had datalogs that looked like a roller coaster, and had limp modes.

Mike@N54Tuning.com · 04-09-2015, 10:04 AM

Quote:

Originally Posted by JNAT*

Agreed!

+1

I think the N54 platform is going to go down as one of the best and most tuner friendly engines ever made. In reality for a couple thousand bux you are in crazy HP/TQ territory.

Mike

Starscream · 04-09-2015, 12:26 PM

Quote:

Originally Posted by 335NJ

Had the same issue on a buddies car. Was told by Jon@BMS to set all DUTY BIAS in the interface to 0 or 50. After that, car runs like a top.

THANK YOU!!

Car runs like a champ now

All issues (for now lol) gone

I don't have Meth so I put the values of Meth Safety mode and Meth trigger mode to 3,

don't know if that makes a difference but the car feels great

Internal Combustion · 04-10-2015, 11:09 AM

I just routed my cable through the firewall and borrowed a windows laptop and upgraded to 28. Did the 0 values (does it matter vs 50?)...running E40, so is map 5 still the best option for me?

335NJ · 04-10-2015, 11:14 AM

Quote:

Originally Posted by Internal Combustion

I just routed my cable through the firewall and borrowed a windows laptop and upgraded to 28. Did the 0 values (does it matter vs 50?)...running E40, so is map 5 still the best option for me?

Yes. Map 5 is fine. You can get some datalogs to confirm everything looks healthy if you want.

Mike@N54Tuning.com · 04-10-2015, 03:28 PM

Quote:

Originally Posted by 335NJ

Yes. Map 5 is fine. You can get some datalogs to confirm everything looks healthy if you want.

Ya if ever in doubt just datalog the map.

Mike

idrift4wd · 04-10-2015, 08:40 PM

impressive and exactly what i think a tune+dci car should put out with given mods.

tune e85 should net 400+ given the tune is aggressive enough.

Mike@N54Tuning.com · 04-10-2015, 09:09 PM

Just a note.

***DO NOT UPLOAD FIRMWARE UNTIL YOU READ THIS *** ISO 28.7 and later REQUIRES JB4 INTERFACE 3/1/15 AND SETTING CHANGES. All Duty Bias (formerly CPS) must be set to 0 or 50 to avoid 30FF under boost codes. 3rd gear boost limiting should also be set to 0 to disable. See reference below for default settings. ***

04-08-2015, 10:50 PM	#23
Starscream Colonel 141 Rep 2,120 Posts Drives: ///M Roadster + E92 335i 6MT Join Date: Dec 2007 Location: Park Ridge NJ + Windermere FL iTrader: (23)	I tried this tune today and for some reason it capped my boost at 9psi when hot and 3psi when the car was cold no matter what map I selected, Car felt very slow and stock like I downgraded back to 28.5b and the car went back up to previous boost levels (17/18 with back end flash) and previous higher power What gives? Did I miss a setting? __________________ Imola Red Roadster
	Appreciate 0 Quote

04-10-2015, 11:09 AM	#32
Internal Combustion New Member 2 Rep 18 Posts Drives: Montego E92 335xi Join Date: Apr 2013 Location: Columbus OH iTrader: (0)	I just routed my cable through the firewall and borrowed a windows laptop and upgraded to 28. Did the 0 values (does it matter vs 50?)...running E40, so is map 5 still the best option for me? __________________ 2008 E92 335xi-Sport Package \| 6AT \| iDrive JB4 G5 ISO \| BMS DCI \| eBay Aero lip \| JG M-tech rear \| E40 12.2@115, 1.78 60' (75*, Conti DWS 17" all seasons)
	Appreciate 0 Quote

04-10-2015, 08:40 PM	#35
idrift4wd Brigadier General 151 Rep 3,549 Posts Drives: Three Hundred and Thirty Five Join Date: Jul 2010 Location: Yonkers NY iTrader: (0) Garage List 2007 BMW [7.00]	impressive and exactly what i think a tune+dci car should put out with given mods. tune e85 should net 400+ given the tune is aggressive enough. __________________ 12.0 @ 117
	Appreciate 0 Quote

04-10-2015, 09:09 PM	#36
Mike@N54Tuning.com Joint Chiefs of Staff 5037 Rep 116,174 Posts Drives: 2007 335i, 2015 M3 Join Date: Dec 2008 Location: N54tuning.com iTrader: (89)	Just a note. *DO NOT UPLOAD FIRMWARE UNTIL YOU READ THIS * ISO 28.7 and later REQUIRES JB4 INTERFACE 3/1/15 AND SETTING CHANGES. All Duty Bias (formerly CPS) must be set to 0 or 50 to avoid 30FF under boost codes. 3rd gear boost limiting should also be set to 0 to disable. See reference below for default settings. ***
	Appreciate 0 Quote