[Sensible_]

Also, can you run diagnosis with rheingold? And show screenshots here...

Also I want to see complete module list: show screenshot from INPA UIF...

[Sensible_]

To clarify, some questions:

You have just BMW Professional Radio yes? No CCC / CIC / NBT retrofits?

Programming starts (blue bar percentage?) then fail?

You are using ICOM A-SYNC?

Are all most loop closed?

[ste821]

Originally Posted by Sensible_

To clarify, some questions:

You have just BMW Professional Radio yes? No CCC / CIC / NBT retrofits?

Programming starts (blue bar percentage?) then fail?

You are using ICOM A-SYNC?

Are all most loop closed?

CDC/AMP , dead Radio. no there.
Yes, Programming Start 1st Blue Bar go 100% , then wait 0% after 30-50 Sec later come Error. i post prev.

thx
sanjib

[Sensible_]

Did you try: 9199438

??

Also, consider flash head-unit through OBD only? With diagbus.

[ste821]

Originally Posted by Sensible_

Did you try: 9199438

??

just try, Error 201:
Check hardware number

Wrong ECU hardware number

plz see my photo. here is part Number 6971703 HW # 6952294
i think select worng zusb #

sanjib

[2008-335xi-N54-E92]

Originally Posted by matteblue3er

You should not even be attempting to flash a head unit with a DCAN cable.

Only ICOM!

Your only hope is NFS.

NOT true about updating using DCAN...........Ive done mine with DCAN and it went through.

Here is steps:

1) Make sure you go into INPA choose "all functional jobs" then click on "errors" clear all EM, HM and IM errors. All three must be clear. If its not clear then youll have problems.

2) go to winkfp........choose your ZUSB file which will be "CC6360" or which ever your file name is.

3) Dont choose default ecu.......instead choose "Mensch Maschine Interface RMMI1 erweitert MMI-Front" and NOT choose the "Unverbault"

4) enter VIN

5) Hit "Done"

6) Program ZUSB

MAKE SURE to have your battery charger on at all times because this will take at least 40 min to an hour depending on your computer speed and ram.

[2008-335xi-N54-E92]

Originally Posted by matteblue3er

You should not even be attempting to flash a head unit with a DCAN cable.

Only ICOM!

Your only hope is NFS.

NOT true about updating using DCAN...........Ive done mine with DCAN and it went through.

Here is steps:

1) Make sure you go into INPA choose "all functional jobs" then click on "errors" clear all EM, HM and IM errors. All three must be clear. If its not clear then youll have problems.

2) go to winkfp........choose your ZUSB file which will be "CC6360" or which ever your file name is.

3) Dont choose default ecu.......instead choose "Mensch Maschine Interface RMMI1 erweitert MMI-Front" and NOT choose the "Unverbault"

4) enter VIN

5) Hit "Done"

6) Program ZUSB

MAKE SURE to have your battery charger on at all times because this will take at least 40 min to an hour depending on your computer speed and ram.

[before uzzz]

are you serious update cic with dcan cable only 40 minutes? coz right now im in progress update using dcan ,run 5 hours and i get 11 % 😂 ,winkfp + expert mode+ spdaten 67 , | 63,62,1a , naab 63 is done only 30 minutes ,and right now prog program 11 % ,