[snoozee]

Originally Posted by chupalt

Awesome! I looked in the trunk and there's no MULF2. It sounds like I likely have a newer headunit, but obviously need to verify. If I have a newer headunit, what hardware is required? Do I still need coding?

you'll still need the mic and bluetooth antenna with the necessary wiring. coding as well.

i'll advise you to pull the radio first to confirm that your radio is BT capable before ordering the mic and antenna

[alexwhittemore]

Originally Posted by chupalt

Awesome! I looked in the trunk and there's no MULF2. It sounds like I likely have a newer headunit, but obviously need to verify. If I have a newer headunit, what hardware is required? Do I still need coding?

My advice should be least trusted since I don't know a ton about the new headunits, but I believe this guarantees your headunit has bluetooth as well as USB.

You'll probably need a mic if you don't have voice control (which I believe you don't, since I believe you don't have iDrive?). I don't know whether or not you'll need to run a wire for it, but I'd guess you do.

Then you'll also need coding. I think just +$644 to VO in CAS+FRM, but I'm not sure if that's all.

Edit: At any rate, you're in luck, if you're DIYing it should be nice and cheap! And not MUCH more expensive if you need to pay to have the coding done.

[chupalt]

Thanks for all the help. I'm going to pull the headunit and confirm that I have the new one.

I'll do the coding myself. Doesn't seem too bad, just need to buy the cable and get NCS Expert.