[halcyon026]

Originally Posted by j1gilles

Go WOT in the correct meth map and hit your washers through a whole 3rd gear pull.... I bet you have a little air in the line. My WW kit does the same thing but I purge it once in a while and that helps with flow. Also if you are running above a 50% meth add on hot days meth will evap/boil in the line causing air pockets.

Actually I by-passed the WW line that goes to the WW nozzles. Just to try & eliminate that as an issue. I'm only running 50% & it hasn't been over 85-ish degrees, is that enough to cause it to evap/boil?

[j1gilles]

Originally Posted by halcyon026

Actually I by-passed the WW line that goes to the WW nozzles. Just to try & eliminate that as an issue. I'm only running 50% & it hasn't been over 85-ish degrees, is that enough to cause it to evap/boil?

It could be warm enough... Even if you by-passed the sprayers the extra boost from the WW pump will help to clear any air. Cant hurt...

[gzim335]

Originally Posted by MRVBC

Do yourself a favor and get a trunk mount tank. I didn't listen to everyone and my WW set up leaked and caught fire. Thank God not much damage happened.

+1 happened to me too

[halcyon026]

I tried holding the WW spray stock on while going WOT and the hazards stay on solid...

Is it possible to switch the Vishnu kit to SS lines & not use those push tab grommet things on the pump but put those screw on lines in?