[VNeBLOB42]

Originally Posted by arc1880

Thanks for the clarification. Also, if let's say you get into an accident where you aren't able to turn on the ignition to get a "divorce" from the AP lol, then are you SOL?

that's a good question, I had a similar question on a different thread, but has been deleted.

the response was as long as the car has power and can communicate to the ECU you are good to go.

My specific question was "what if the car had a malfunction, (undrivable) can I re flash to stock before going to the dealer"

[VNeBLOB42]

Originally Posted by Dethsupp0rt

There's a new update (v1.6.5.0-4570), so maybe give that a shot.

I haven't had your specific problem, but I do remember having a problem with the AP just dropping communication with the ECU whilst logging. I haven't had the issue the last few times though, so perhaps it was fixed with a later firmware.

Ive tried and it appears I have the latest firmware as per what my AP Manager says.

[benzy89]

Originally Posted by arc1880

Thanks for the clarification. Also, if let's say you get into an accident where you aren't able to turn on the ignition to get a "divorce" from the AP lol, then are you SOL?

Remember, when you flash the car is OFF. So let's see you get in an accident (God forbid) or for whatever reason the engine won't turn on. As long as you can get the Auxiliary Power on (radio, fan blowing, headlights on), you'll be able to flash back to Stock before the tow truck shows up.

[type rrr]

Originally Posted by Carl Morris

I have but I didn't notice any effect. Adjusting some of the other WGDC tables did help me hold boost better at high rpms, though. I'm still below target from 5500rpm and up, but not so badly as before. Has anyone else seen a difference on stock turbos using more than 57% WGDC?

what table we need to change to hold the boost better ?

WGDC ceiling - adder ?
- spool ?
- base ?

thank s

[bboy8282]

Does anyone have or can link me to a dyno that shows a Stage 1 +FMIC is more powerful than a Stage 2...just wondering if i should get dps or not...cuz if the above is true...why even bother with a catless dps (esp if you live in California where it has the most strict emission laws) when a Stage 1+ FMIC gives u more power

[Bash]

Originally Posted by bboy8282

Does anyone have or can link me to a dyno that shows a Stage 1 +FMIC is more powerful than a Stage 2...just wondering if i should get dps or not...cuz if the above is true...why even bother with a catless dps (esp if you live in California where it has the most strict emission laws) when a Stage 1+ FMIC gives u more power

Yeah but with DPs you'll run S2+ which is fastest OTS map Cobb has.

[ihc95]

Officially part of the COBB crew!!!!

[JStang]

Originally Posted by ihc95

Officially part of the COBB crew!!!!

Welcome!!

[ihc95]

Hey guys quick question. When installing the AP on the car the car is on the 'power' cycle with the engine off. The problem is my angel eyes are on and Im afraid its going to drain the battery preventing my car from starting. Does everybody's angel eyes stay on? The reason I ask is that my car has aftermarket BMS LED AE's so maybe they are on during the power cycle but the stock ones arent?

[jcarv20s]

Must be cause I turned the lights completely off when upload my Cobb

[VNeBLOB42]

Originally Posted by ihc95

Hey guys quick question. When installing the AP on the car the car is on the 'power' cycle with the engine off. The problem is my angel eyes are on and Im afraid its going to drain the battery preventing my car from starting. Does everybody's angel eyes stay on? The reason I ask is that my car has aftermarket BMS LED AE's so maybe they are on during the power cycle but the stock ones arent?

well with stock, angel eyes only come on after two hits with the start button. When installing COBB, just hit the button once. With iDrive you can turn running lights (angel eyes) off also.

with aftermarket, not familiar but can't you just disconnect from the battery? then connect after install? Or just hook up a battery charger while installing, I only do that when I am installing the COBB. Uninstall and MAP switch I just turn off nav screen, a/c and bluetooth.

[VNeBLOB42]

Originally Posted by bboy8282

Does anyone have or can link me to a dyno that shows a Stage 1 +FMIC is more powerful than a Stage 2...just wondering if i should get dps or not...cuz if the above is true...why even bother with a catless dps (esp if you live in California where it has the most strict emission laws) when a Stage 1+ FMIC gives u more power

I think you are requesting to install FMIC instead of DP's?

I am going this route anyways. In a few weeks I should have a Pro Tuned S1+ E85 with Dyno results. As for S1+ Sport vs S2 Sport (no FMIC) I am not sure which has more HP. In Cali, I am getting high IAT (IC Air Temp) 140+ deg @. +-90 deg. outside) which doesn't help with performance. I would suggest getting the FMIC first, you can always add DP's later and go S2+ at that time. S1+ Sport you should see about +20 - 30 rwhp, from S1 Sport

to get a rough estimate, look at the MAP notes, S1 Sport is 26% increase HP for Manual, and add roughly 20 - 30 hp and you can get close to S1+ Sport. The MAP notes don't say anything for S2 Sport, just S2+.

I just don't want to go the DP route until my warranty is up. Emissions its only every two years, so that's not so bad.

oh yeah,

if you can get your hands on some E85 about 20% you can do Sport and Aggressive. I was having issues with Running S1 Sport with 91. ACN fuel is no bueno!

[ihc95]

Originally Posted by jcarv20s

Must be cause I turned the lights completely off when upload my Cobb

I have my lights completely off. The angel eyes stay on.

[ajsalida]

Originally Posted by ihc95

I have my lights completely off. The angel eyes stay on.

You can and should turn off DRL's (angel eyes). In cars with iDrive you do it through settings menu. I am sure it is similar with non idrive cars

[ihc95]

I installed my COBB and HOLY SHIT!! This thing fucking rips now. I never experienced power like this. It was so easy to install. I was afraid my battery would get drained because of the angel eyes being on. However the car started perfectly fine with no hesitation. The best part of it all, it feels completely normal during regular driving. There is still gobs of low end torque just like stock and there is no increase of lag (opposite actually). The car feels god like haha. Sorry Im still on the "initial shock" but the increase in performance is undeniable.

I do have one question tho. During one of my pulls, I had a friend behind me and he said there was white smoke coming out of my exhaust tips. During this pull I did not give it full throtte (~75%). I am on the Stage 1 Aggressive Map running on Hess 93 w/ 10% E85. My assumption is that the ECU is still learning the air and fuel ratios and the smoke will stop when the car fully adapts. Any other thoughts? Is it something I should be worried about?

Other than that though, the Cobb AP is the best purchase I've ever made (apart from the actual car of course ). Thanks Cobb!!!

[Ænema]

More than likely just a little bit of condensation not really smoke.

[ihc95]

Originally Posted by Ænema

More than likely just a little bit of condensation not really smoke.

says a guy with 3 posts. thanks a lot.

[type rrr]

Originally Posted by ihc95

I installed my COBB and HOLY SHIT!! This thing fucking rips now. I never experienced power like this. It was so easy to install. I was afraid my battery would get drained because of the angel eyes being on. However the car started perfectly fine with no hesitation. The best part of it all, it feels completely normal during regular driving. There is still gobs of low end torque just like stock and there is no increase of lag (opposite actually). The car feels god like haha. Sorry Im still on the "initial shock" but the increase in performance is undeniable.

I do have one question tho. During one of my pulls, I had a friend behind me and he said there was white smoke coming out of my exhaust tips. During this pull I did not give it full throtte (~75%). I am on the Stage 1 Aggressive Map running on Hess 93 w/ 10% E85. My assumption is that the ECU is still learning the air and fuel ratios and the smoke will stop when the car fully adapts. Any other thoughts? Is it something I should be worried about?

Other than that though, the Cobb AP is the best purchase I've ever made (apart from the actual car of course ). Thanks Cobb!!!

nothing to worry about,,,normal

[ihc95]

Originally Posted by type rrr

nothing to worry about,,,normal

even on a completely stock car? I thought smoke only occurred with down pipes...

[benzy89]

Originally Posted by ihc95

says a guy with 3 posts. thanks a lot.

The guy with 3 posts was probably right. Smoke is more pronounced when you go catless (whether its just DPs or full turbo-back catless), but you still get white smoke on completely stock cars usually resulting from the evaporation of water in the tailpipes/mufflers. Did you let the engine warm up (oil temps in 200* area) before you started ripping on it?


I really hope so

[ihc95]

Originally Posted by benzy89

The guy with 3 posts was probably right. Smoke is more pronounced when you go catless (whether its just DPs or full turbo-back catless), but you still get white smoke on completely stock cars usually resulting from the evaporation of water in the tailpipes/mufflers. Did you let the engine warm up (oil temps in 200* area) before you started ripping on it?


I really hope so

Yes I did. I actually drove a lot before installing the AP to make sure the battery was charged. Oil temps were around 230-240. Why do you think there was smoke?

[VNeBLOB42]

Originally Posted by ihc95

says a guy with 3 posts. thanks a lot.

Lol, there has been people getting banned, so by the post doesn't necessarily mean noob.

Could be a returning enthusiast.