[MACKENZIE2576]

Sis you follow the code I wrote above in post?

[MACKENZIE2576]

Do you mind taking a screenshot of the part you're on about. All I did I think was set it as Activ if I'm not mistaken.

[aaronwints]

Originally Posted by MACKENZIE2576

Do you mind taking a screenshot of the part you're on about. All I did I think was set it as Activ if I'm not mistaken.

Hey Ive just retrofitted this to my 1 series - post was super helpful so thanks for all the info. One thing I’m not sure of… my auto wipers still seem to just run intermittently, I coded default all the listed modules. Also the auto lights only seem to work if i shine my torch right onto the sensor - wondering if I may have a dodgy RLS

[RonnyS]

Hi, i'm about to buy all the part for the retrofit but i have a question. My E90 has Xenon Light from factory. Does this affect the procedure of the installation?

[MACKENZIE2576]

Originally Posted by RonnyS

Hi, i'm about to buy all the part for the retrofit but i have a question. My E90 has Xenon Light from factory. Does this affect the procedure of the installation?

Yes Bro will work no issues

[Nobeard]

@MACKENZIE2576 Hello all - I did this retrofit a month or two ago and followed it up with power fold mirrors at which point I found my FRM was failing. Before and after replacing the FRM the auto wipers and lights work as expected but going into coding for light sensitivity etc. none of the options I choose 'stick' - if I go back in to check what is set everything reverts to what it had been previously. I have tried factory coding RLS but get an error saying problems calculating coding data. I also tried another RLS module with same result. I'm mostly using BimmerGeeks Protool but have also tried NCS Expert - any ideas?