[Mr. Hankey]

Originally Posted by canDO_Stef

That is the process for the vast majority of CAN messages, yes. And your custom message becomes part of your Actions database, exactly as you say.

There are hundreds of messages per second on the bus, so using canSPY, you would start recording the "chatter", which adds the devices to a blacklist, so you can more easily narrow down the events you're looking for. Once you figure out a specific ID for a device, the simplest approach is to whitelist that ID and focus only on those messages.

Thanks for all your replies to the above point -- Rev matching off/on is likely going to the DME, not sure if you know the DME address (or message id) but that is where I will start looking for the commands to be going. In any event, excited - no need to reply to this Stef! Need a car first haha.

[canDO_Stef]

Mr. Hankey

As part of our upcoming firmware update, certainly in time for when you get your car!



Just sayin'...

[Mr. Hankey]

Originally Posted by canDO_Stef

Mr. Hankey

As part of our upcoming firmware update, certainly in time for when you get your car!



Just sayin'...

Love it! And your timing is impeccable.



Just sayin'