[slimxb8]

Ok so what's the trick with this stuff?
I've tried this stuff before and after the coating and it's by far the worst stuff ever. All it does is leave greasy streaks. I tried using 4 new cloths and still can't get it off. Finally I used some poor boys detail spray to clean it up. For $50 I want to be able to use it lol...

[Detailed Image]

Please explain your exact process... how much are you applying? How are you applying it? How big of a spot are you working on at a time? Are you letting it dwell/dry before removing? Any information you can provide will help me to help you.

I just did a demo of this product for a customer yesterday when they were picking their car up and it is a breeze to use in most cases... there have been a few cases where I have had troubles with it, but it is almost always on freshly coated jet black cars. Once a coating has been completely cured (as in weeks later) I have not encountered issues with VS1.

I apply it by spraying a couple of light mists onto a microfiber towel or microfiber applicator, then spread it over a small area and immediately wipe off with another clean towel. The trick is to use very little product. If you use too much it will be a pain (the same goes with most coating topper products).

Zach McGovern
Detailed Image Ask-A-Pro Blog Author
www.AttentiontoDetailingPeoria.com

[slimxb8]

Well I tried a couple different methods... 1st was 2 or 3 mists on the mf. Wiped on, flipped towel a few times to dry. Looked ok till saw sun in it and it was swirl city. Went thru a few mfs trying to buff it off.

Also tried a spot misting it as well with same follow up.

About 15 min lapsed before I had to get the poor boys spray... and never did get it off before that.


Same results a few weeks ago before coating. Did half my trunk in wax and half vs1.

[Detailed Image]

...Let me see if I can get a video applying it here in the next week or so...

-Zach