05-09-2024, 02:12 PM | #1 |
Private
21
Rep 66
Posts |
Dashcam setups
I have a dashcam powered by the cigarette lighter and was wondering how some of you run it? I run mine through the panels on the passenger side into the footwell then back up to the door then the roof. Its a clean look except for the center console not being able to close. Was wondering if anyone else here has the same setup and maybe found an extension or something that would allpw for the center console to close again?
(Car is currently at the dealership so I can't show pics until I get it back) |
05-09-2024, 03:11 PM | #3 |
Private
94
Rep 51
Posts |
I have a Viofo A229 Pro that I’m planning to hardwire to fuse box using a helpful G80 thread someone has done before. You should be Ok as long as you set the parking mode short enough/turn off parking mode so that Infotainment system won’t yell at you draining the battery.
I like parking mode and my original plan is to route an external battery to connect to fuse and power the dash cam that way, unfortunately I can’t find a good spot to place the battery since under both seats it’s already packed with lots of stuff and I don’t really want to go thru the hassle to place that in my trunk…for now I’m just gonna hardwire with parking mode set to max 2 hours. |
Appreciate
0
|
05-09-2024, 08:51 PM | #5 |
New Member
6
Rep 10
Posts |
I wired my race-keeper camera into the rear view power. I used posi-taps to tee off the ign+ and ground wires of the black plug. The race-keeper is 5v so I used a small 12vdc to 5vdc converter. I heat shrieked the converter and it tucked nicely into the rear view cover.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|