|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
I need help with these codes
|
|
10-07-2024, 10:54 PM | #1 |
Registered
2
Rep 5
Posts |
I need help with these codes
Car still has power but has no crank any help?
P0306 Cylinder 6 Misfire Detected P0306 Cylinder 6 Misfire Detected P0491 Secondary Air Injection System (Bank 1) P0015 Exhaust Camshaft Position Timing - Over-Retarded (Bank 1) P0304 Cylinder 4 Misfire Detected P0305 Cylinder 5 Misfire Detected P0303 Cylinder 3 Misfire Detected P0302 Cylinder 2 Misfire Detected P1625 Pedal Position Sensor Potentiometer Supply Channel 2 Electrical P1224 Pedal Position Sensor 1 and 2 Circuit Range/Performance P10FD VVL-Sensors Circuit Low P0123 Throttle/Pedal Position Sensor A Circuit High Input P0222 Throttle/Pedal Position Sensor B Circuit Low Input P110D Throttle Position Sensor A and B Circuit Range/Performance (Bank 1) Secondary DTCs 5E1A DSC: Engine Management: Interface 5DF4 DSC: Battery Voltage Too Low; Open Circuit Cold Start 'A' Camshaft Position Timing Over- Retarded Bank 1 Secondary Air Injection System (Bank 1) Exhaust Camshaft Position Timing - Over- Retarded (Bank 1) Cylinder 4 Misfire Detected Cylinder 6 Misfire Detected Cold Start 'A' Camshaft Position Timing Over- Retarded Bank 1 Secondary Air Injection System (Bank 1) Exhaust Camshaft Position Timing - Over- Retarded (Bank 1) Cylinder 4 Misfire Detected DSC: Performance Reduction DSC: Engine Management: Interface DCC Fault: No Repair Measures Necessary Last edited by e90.Alex; 10-07-2024 at 10:55 PM.. |
10-08-2024, 12:41 AM | #3 | |
Registered
2
Rep 5
Posts |
Quote:
I changed the old battery with a new thinking it will crank but nothing really happed, it just cranked for about a sec or so. I checked the voltage and it’s at 12.1v |
|
Appreciate
1
StradaRedlands6189.50 |
Yesterday, 02:07 AM | #4 |
New Member
12
Rep 16
Posts |
I am an amateur but I saw this code in all of the ones you posted.
You said the battery is fine but this code was on your list: DSC: Battery Voltage Too Low; Open Circuit |
Appreciate
1
StradaRedlands6189.50 |
Bookmarks |
|
|