[BabyJayy92]

-2008 328i Sedan
-Engine: 3.0-L L-6 DOHC 24V


So I recently had to have my fuel pressure regulator & fuel feed lien that connects into the top of the regulator replaced due to the fuel feed line leaking gasoline due to being cut. However with both parts replaced & installed my car is now throwing these codes as listed below & it's idling higher than usual on start up as if I were pressing my accelerator down. After a few seconds it idles to normal but it'a also throwing a low coolant level light but my coolant is filled up & if I top it off anymore then I'm going to overfill my coolant tank reservoir. Is my car safe to drive until I can try to get it to the mechanic tomorrow after work???? Someone help me please


•29E0 - mixture control
•29E1 - mixture control 2
•2A15 - DMTL minor leak
•29CD - Combustion cylinder misfire

[e91Owner]

Originally Posted by BabyJayy92

-2008 328i Sedan
-Engine: 3.0-L L-6 DOHC 24V


So I recently had to have my fuel pressure regulator & fuel feed lien that connects into the top of the regulator replaced due to the fuel feed line leaking gasoline due to being cut. However with both parts replaced & installed my car is now throwing these codes as listed below & it's idling higher than usual on start up as if I were pressing my accelerator down. After a few seconds it idles to normal but it'a also throwing a low coolant level light but my coolant is filled up & if I top it off anymore then I'm going to overfill my coolant tank reservoir. Is my car safe to drive until I can try to get it to the mechanic tomorrow after work???? Someone help me please


•29E0 - mixture control
•29E1 - mixture control 2
•2A15 - DMTL minor leak
•29CD - Combustion cylinder misfire

Did you check to make sure the regulator was plugged in?