Changing just the leather door insert

incantana · 11-05-2012, 05:52 PM

Cant find any info on this. Is there a way to just remove the leather insert on the door panel and replace it? Or is it permanently attached to the door panel?

1QuikWS6 · 11-06-2012, 04:54 AM

Well kinda/sorta permanent. AFAIK, they have plastic attachment studs - insert is installed with pins thru matching holes in panel, then the pins are melted/sonically welded on backside to mushroom over a head to retain the insert.

You could carefully re-melt the pins on backside of panel to release the insert - but you would need to be careful not to remove any of pin length as they will need to be melted over yet again when you put the insert back on and there needs to be enough pin protruding thru hole to melt over...

Shinzi · 11-06-2012, 12:00 PM

I saw somewhere that someone just cut the pins and used self tapping screws to reattach the panel.

11-05-2012, 05:52 PM	#1
incantana Captain 44 Rep 662 Posts Drives: 2019 Z06/Z07 3LZ; 2008 E93 M3 Join Date: Apr 2011 Location: USA iTrader: (3)	Changing just the leather door insert Cant find any info on this. Is there a way to just remove the leather insert on the door panel and replace it? Or is it permanently attached to the door panel? Last edited by incantana; 11-05-2012 at 06:02 PM..
	Appreciate 0 Tweet Quote

11-06-2012, 04:54 AM	#2
1QuikWS6 No 55mph 1627 Rep 8,495 Posts Drives: F32 435ix MSport Join Date: Jul 2009 Location: Blitzburgh, PA iTrader: (113) Garage List 2022 BMW M440ix Vert [0.00] 2015 BMW 435ix MSport [0.00] 2000 Pontiac Trans Am [0.00]	Well kinda/sorta permanent. AFAIK, they have plastic attachment studs - insert is installed with pins thru matching holes in panel, then the pins are melted/sonically welded on backside to mushroom over a head to retain the insert. You could carefully re-melt the pins on backside of panel to release the insert - but you would need to be careful not to remove any of pin length as they will need to be melted over yet again when you put the insert back on and there needs to be enough pin protruding thru hole to melt over... __________________ F32 435ix//MGM//M Sport-Prem-Tech-Driver Assist-Lighting-Cold Weather-Dyn Handling Pkgs//M4 Black Lthr Int w/M4 Alum Blade Trim//HK w/Bavsound Stg3//763M//M4 Euro LCI Tails//M4 Mirrors w/CF Covers//AWCarbon CF F/R Spoilers-Side Splitters-Diffuser 6WB/ID6 HU+HUD/IND M4 Alcantara Armrest//PURE S2 Turbo//AA FMIC+DP//ER CP+TIC//3.5bar TMAP/TS DV//AWE Tuning Exh w/Blk Tips//Turner MS CF Intake//BM3 Cary Jordan Tune//MPerf Diff//PrecRW Ignition Kit
	Appreciate 0 Quote

11-06-2012, 12:00 PM	#3
Shinzi Lieutenant 11 Rep 459 Posts Drives: 335XI Join Date: Jul 2012 Location: Georgia iTrader: (1)	I saw somewhere that someone just cut the pins and used self tapping screws to reattach the panel.
	Appreciate 0 Quote