|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Fuel Mode 22 and Rail Pressure Spike at Idle
|
|
07-06-2022, 04:10 PM | #1 |
Major
94
Rep 1,075
Posts |
Fuel Mode 22 and Rail Pressure Spike at Idle
Anyone know what fuel mode 22 and a surging rail pressure at idle means? Rail pressure oscillates between 680ish to over 2100psi at idle and changes from Fuel mode 2 to 22 when the rail pressure spikes and then changes back to 2 when rail pressure comes back down to normal. Is this an injector issue? My bank 1 afr is also slow to respond when lifting off throttle, i.e., bank 2 afr goes to 234 when lifting off throttle but bank 1 doesn't reach 234 or reaches it much slower than bank 2. Injectors are Index 12 and almost 2 years old. Spark plugs are brand new, coils are b58 coils and 2 years old. HPFP is probably the oldest part on the car and was replaced in 2015. Car is 2009 N54 335xi.
Any ideas on if this is normal or an issue? I continue to get some lean to rich afr oscillations when driving in low load/vacuum state and think fuel mode 22 might be the issue there as well...need to log.
__________________
335xi
|
07-06-2022, 04:27 PM | #2 | |
Brigadier General
978
Rep 3,219
Posts |
Quote:
AFR's not shooting upto straight away to 234 when you go off throttle could indicate leaking injectors. Pull the plugs and inspect all of them for fuel, smell of gasoline etc Since your at it, may as well check all injectors visually and recode all of them. Make sure to replace seals. Last edited by Saif2018; 07-06-2022 at 05:23 PM.. |
|
Appreciate
0
|
11-03-2024, 11:18 AM | #5 |
Private
38
Rep 96
Posts |
Is it switching back and forth between fuel modes? Fuel mode 2 is normal operation and fuel mode 22 is spool mode. In spool mode the DME references different fuel, timing tables, etc. Something is telling the DME to fluctuate between the modes. My guess is throttle related issue. Are you able to send a log so we can see what the other parameters are doing
|
Appreciate
0
|
11-04-2024, 05:25 PM | #7 |
New Member
0
Rep 5
Posts |
i haven’t checked what mode it’s in i just saw that my fpr psi went to 2300 at idle and made injectors sound crazy, but only at idle so far, is this the same for u? also how do u check the mode
|
Appreciate
0
|
Bookmarks |
|
|