|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Limp mode after hard pull in DS or M mode
|
|
01-20-2021, 12:43 AM | #1 |
Pablo Perrico
0
Rep 9
Posts |
Limp mode after hard pull in DS or M mode
After I make a hard pull or just even drive for a while in DS or M mode, the engine goes into limp without any codes. I don't know if I'm not supposed to drive for awhile in those modes or what.
Also can anybody tell me what "Lambda probe downstream of the cat 2, trimming control" means? I know it's a downstream O2 sensor but was wondering if anybody knew which one it was out of the 2 after the cat? Another question, is there a Low pressure fuel sensor on this engine? Im getting a "misfire at low tank level"and I was thinking it might be below the throttle body but not sure. I've replaced my gas cap as a the easiest thing to do first. N51 engine 158xxx miles No mods besides a muffler delete |
Bookmarks |
|
|