|
|
|
|
 |
 |
 |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
 |
|
BMW 3-Series (E90 E92) Forum
>
Removing the cylidner head with engine in car....
|
 |
| 08-28-2024, 10:23 AM | #1 |
|
Brigadier General
 
2089
Rep 3,809
Posts |
Removing the cylidner head with engine in car....
I need to replace the head gasket on my engine. The new Elring head gasket I installed on my freshly built engine is junk....leaking cooling externally out of it. Sounds like lots of guys have been having issues with these junk Elring gaskets.....they must have had a defective batch or something.
That being said, I really don't want to pull the motor out again. It was a royal pain in the butt. I'm going to try to pull the head with the engine still in the car. I'm assuming I can pull the turbos off, and just move the manifolds over until they clean the studs coming out of the head....and then just pull the head right off. Anyone ever done this? Any tips or tricks?
__________________
2007 335i, BMS DCI, BMS Chargepipe w/Tial BOV, ARM Catless Downpipes, silicone inlets, Bilstein B12 Prokit Suspension, Whiteline subframe bushings, Front/Rear M3 control arms, G-Plus FMIC, Stage 2 LPFP, Custom E40 tune by Justin (V8Bait), xHP stage 3 transmission flash, RB Two Turbos....10.90 @ 128mph
 |
| 09-17-2024, 03:04 PM | #2 |
|
Brigadier General
2089
Rep 3,809
Posts |
Nobody has done this?
__________________
2007 335i, BMS DCI, BMS Chargepipe w/Tial BOV, ARM Catless Downpipes, silicone inlets, Bilstein B12 Prokit Suspension, Whiteline subframe bushings, Front/Rear M3 control arms, G-Plus FMIC, Stage 2 LPFP, Custom E40 tune by Justin (V8Bait), xHP stage 3 transmission flash, RB Two Turbos....10.90 @ 128mph
|
|
Appreciate
0
|
 |
| Bookmarks |
|
|
