[GOWRIN]

So soon after installing and trying some coding I realised the LCI headlights were not like the rear lights.

Ordered a FRM3 module, arrived today, took apart the car and installed it hoping it would be magically plug and play. Nope!
Instead no lights working and threw up error code CC ID 231 & 354.

Done some research and looks like I need to program (flash) it as well as code.

Do I Flash the module with my VIN first and the restore to factory setting using the code below or other way around?

1.Open NCSEXPERT
2.File > Load profile > Select Expertmode > Click OK
3.Press F1 (VIN/ZCS/FA)
4.Press F3 (CS/FA f. EC) > Select E89 > Click OK > Select CAS > Click OK
5.Press F6 (Back)
6.Change job to SG_Codiren
7.Execute job

And I have read to flash the module to use WinFKP or Tool32 (I assume this is when you enter the VIN and Date) Can't seem to find steps on this so if any one can lend a hand it would be much appreciated

[GOWRIN]

So tried this for hours, can't get winfkp to work properly, won't get assembly line info. Seems more complicated that it sounds.

[chriz1]

I know someone who can code this remotely for you, will Pm you now

[Sensible_]

I can help you

What stage are you at exactly? Do you have a working INPA / NCSEXPERT setup?

Also, is the FRM3 used or new?

[GOWRIN]

Originally Posted by Sensible_

I can help you

What stage are you at exactly? Do you have a working INPA / NCSEXPERT setup?

Also, is the FRM3 used or new?

Thanks, turns out it was a faulty module, will get another one and try again and will give you a shout if it fails.