|
|
|
|
 |
 |
 |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
 |
|
BMW 3-Series (E90 E92) Forum
>
Speed Delimit Instructions... Correct?
|
 |
| 01-28-2008, 08:40 AM | #1 |
|
M Master
78
Rep 551
Posts |
Speed Delimit Instructions... Correct?
Im a little confused with the delimit directions.. For Autobahn Use
Is this correct? Using the Green Loom which was replaced with V2.. Connect.. Black Wire (Green Loom) is put into Procede Black Connector Pin 4 Green Wire (Green Loom) goes into Procede Black connector Pin 9 Remove Female pin #17 on Grey small Ecu connector. Insert into Male end of Green procede Loom (Wire that comes out of Pin 4 Procede connector) Connect Female End of Green Loom into Pin #17 Slot of Grey Ecu, Green Female end is connected to Procede Black Connector #9, Thanks and cheers! Last edited by rambino; 01-28-2008 at 10:01 AM.. |
| 01-28-2008, 10:49 AM | #2 |
|
Major General
145
Rep 6,608
Posts |
Shiv said not to do this yet because it has been causing problems...
__________________
 |
|
Appreciate
0
|
| 01-28-2008, 05:36 PM | #3 | |
|
M Master
78
Rep 551
Posts |
Quote:
Huh?! im here every day.. i did not see his post.. link? what sort of problems? I am out here in the Autobahn world where its Legal and My car is modded in a way to make high speed safe.. Also his V2 maps are named Speed Limit / De-Limited Im assuming thats for a reason to allow this option for people like me or dyno usage.. |
|
|
Appreciate
0
|
| 01-28-2008, 05:41 PM | #4 |
|
Lieutenant
 
24
Rep 464
Posts |
__________________
2021 AMG E63S Hammer Wagon
2002 BMW Z8 (with a Dinan DP Engine) 1996 Porsche 911 (993) Turbo 1995 Ferrari F355 Berlinetta 6mt 1964 Porsche 356 C Coupe |
|
Appreciate
0
|
 |
| Bookmarks |
|
|
