[themonotron]

Hi Guys, I just finished installing the hardware aspect of the V2, and with latest v2 software loaded, the car started fine, no hesitation or CEL lights. The problem came when I tried accelerating, my laptop is showing only a .3 psi boost, and when I do further acceleration, the CEL light comes on. At first the code was PO335, but now the code isn't even there. Anyone else have this problem? Any help would be much appreciated.

[bmwzimmer]

loose White Loom or loose Ground wire from the black connector.

[remydlc]

Originally Posted by bmwzimmer

loose White Loom or loose Ground wire from the black connector.

+1 Pin# 29 of the white colored loom.

http://www.vishnutuning.com/images/B...oublecodes.jpg

[themonotron]

I just doubled check all the connectors, even the ones from the ecu, and the same problem persists. Is it possible that I installed it improperly? or would that throw other codes at start up? Could it be hardware related, i.e. vacuum tubes? Thanks.

[remydlc]

Originally Posted by themonotron

I just doubled check all the connectors, even the ones from the ecu, and the same problem persists. Is it possible that I installed it improperly? or would that throw other codes at start up? Could it be hardware related, i.e. vacuum tubes? Thanks.

I had a problem with my install too. By mistake instead of inserting the female of the green loom into pin #10 i did in 12, so is possible something similar happened to you. print the following manual up, it may help you, i think is the best out there:

http://www.vishnutuningforum.com/for...read.php?t=343

[themonotron]

OK thanks, i'll check it out!