[grizz311]

I installed jb4 the other day, turned on the car a couple of times and everything looked good. Next day i installed an er charge pipe. I noticed that there was a lot of oil in the charge pipe and on the tmap sensor. When i turned on the car i got a check engine light with the code p0108 which is for a map sensor. I took out the sensor cleaned it with maf cleaner and put it back into place, cleared the code and drove around for a while. After restarting the car, the code came back. Any ideas or should i just put auto clear on? Car seems to run normally with nothing different

[grizz311]

Any thoughts?

[weehe126]

Did you unplug the connector when switching CP? Could just be from the car seeing it was not plugged in while awake but not on.

[grizz311]

Originally Posted by weehe126

Did you unplug the connector when switching CP? Could just be from the car seeing it was not plugged in while awake but not on.

I am pretty sure that I didn't unplug it. Either way I took the whole thing out cleaned it with MAF cleaner put it back in, reset the code, and it is still coming up. Very weird.