[specialist]

So I installed the dp fix and no codes or SES light. I have put 100km on it so far no problems. I set the dial to 6pm

I own a 2007 bmw 335i.

I followed instruction from the BMS

Extract these three wires:
19 (yellow wire, number stamped on insulation)
20 (yellow wire)
23 (black/red wire)

After i do the e-test i am going to remove it because apparently it mess up the fuel trims.

When i am going back to stock can some confirm this

19 (yellow wire, number stamped on insulation) I want to know if it actually had the number stamped on it.

I think when i was doing mine i saw the number stamped on the 20 position

Please let me know.

[andydna15]

Mine had numbers on pin 20 not 19. Just make sure you put each pin in the same location you removed them from.

[specialist]

I just wanted to make sure I was just doubting my self

[cya]

Both my yellow wires looked identical. I just wrote on the masking tape where each one went.

[specialist]

damn