[drmjm1]

OK, so I was finally able to track down and install ISTA/P 3.60 and get it up and running. I have a replacement battery which is 93.5 Ah instead of my old 70. I want to recode for the change. I registered it with BMWlogger.

I don't want to perform any other coding, and ISTA seems to want to recode every module. I was able to go into each individual module and select Hide to remove most of the codes. I have a few left which are unwanted, initializing front & rear windows & sun roof, steering angle sensor adjustment, and reset of digital engine electronics adaptation values and variant.

Is there a way to remove the other actions from the measures plan?
I am worried that the Reset Digital Engine Electronics Adaptation Values and variant will screw up my MHD-Flasher Stage 1 tune.

Any help would be greatly appreciated, I'm a total newbie at coding, so I'm hoping a few knowledgeable people on here can help. I have been researching this all over the internet on bmw coding sites for a week now, several hours a day, and have not found a guide to this easily with ISTA/P 3.60 All my car stats are in the signature. The new battery is a Napa Battery - NAPA Legend Premium 84 Month Part #8449, reserve capacity is 155 min, 155/2+16=93.5 Ah.

I don't have NCS or any other software, just ISTA. Here is a screenshot of how far I was able to get. Also a screenshot of the errors I'm getting.

Thanks very much guys!

[Levanime]

What are you trying to do?

You have already registered battery right?

[dstrickland]

Originally Posted by Levanime

What are you trying to do?

You have already registered battery right?

NCS is much easier for this kind of thing.

[drmjm1]

Originally Posted by Levanime

What are you trying to do?

You have already registered battery right?

Registered the battery using BMWlogger. Now I need to recode for a 90 Ah battery instead of the old 70 Ah.

[drmjm1]

Originally Posted by dstrickland

NCS is much easier for this kind of thing.

Ok, looking into NCS. Thanks for the tip!