[808AWD325xi]

Hi,

I'm trying to figure out how to read the mileage stored in the EGS module. The Tool32 job quicktest should display it. However, when I run the job, it returns 0 km:


I suspect that it's not working on my transmission because I have a very early firmware release.

Can you run the quicktest job and post your results?

- Run Tool32 and go to File -> Load SGBD
- Scroll down the list and select GS19D.PRG. Click on Open.
- Scroll down the list of jobs and highlight quicktest
- Go to Job -> Start job once only

Thanks !!

[808AWD325xi]

Originally Posted by BimmerGeeks

0KM as well 06' E90, latest firmware available(V53 I think. Are we sure EGS stores mileage?

I support the cause boss, I see the thread this probably relates too.

Thanks for checking.

The status_timeoutdiagnose job reports kilometerstand timeout diagnostics are active which further suggests the EGS stores mileage. But, I've found other jobs that are just stubs.

[808AWD325xi]

Originally Posted by BimmerGeeks

Ive got a few other cars with various egs modules at the shop, Ill test with them as well. Will report back tomorrow.

Any luck?