[milfriez]

It's not a tool that you'll have to use often. *hopefully*

Was looking to see if anyone had one to sell, or one I could pay to *rent* off them to change out injectors. Not sure if it's 100% necessary, but I don't want to start ripping things apart and get halfway through and can't get an injector out.

Any info, hit me up!

[big_ed]

Um you can't just take the n54 injectors out after properly taking apart a few tings...

Have you looked up the diy?

[milfriez]

Originally Posted by big_ed

Um you can't just take the n54 injectors out after properly taking apart a few tings...

Have you looked up the diy?

Yea, I looked up the DIY, multiple different ones actually. Not all of them say to use it, but some say if they are stuck good, to get the puller. It's almost like a reverse hammer to get them up and out. Being that mine is a 2007, I have learned that if something can go bad/break/get stuck, most likely it will be. So I just wanted to err on the side of caution.

[big_ed]

Originally Posted by milfriez

Yea, I looked up the DIY, multiple different ones actually. Not all of them say to use it, but some say if they are stuck good, to get the puller. It's almost like a reverse hammer to get them up and out. Being that mine is a 2007, I have learned that if something can go bad/break/get stuck, most likely it will be. So I just wanted to err on the side of caution.

Don't worry about it too much, I have an 08 and at most just remember using a plier to pull any injector putting up a fight. Just make sure if that ends up being the case, you pull your injector straight up and not at any funny angles or anything to avoid any issues.

[kfrazie1]

Just use a piece of rope. Works fine. I've done this 2 or 3 times using rope.