[datbimmer]

Hi,
I'm doing comfort access retrofit and don't feel like spending 200$ for a pre-made harness. I'm sure I can make the harness myself for much cheaper. I found the pinout for the module and have a good idea how to make the harness myself. It would really help me if someone could point out to exactly where the best place would be to plug these in:

Bus cable 1 for K-bus

K-CAN Low

FBD receiver actuation

BUs cable 2 for K-bus

Terminal 30, power supply

K-can High

Terminal 31, earth ( I guess this one is easy )

Bus cable 3 for K-bus

[datbimmer]

I was able to figure out most of them. At this point I am not sure about X15005, X15006 and X10134.

[PichaDis11]

Originally Posted by datbimmer

I was able to figure out most of them. At this point I am not sure about X15005, X15006 and X10134.

X15005 & X10134 are KCan HL. You can grab this in the harness running just above the battery area. Just make strong connections.

X10134 you may need to run all the way to the CAS.

[datbimmer]

Originally Posted by PichaDis11

X15005 & X10134 are KCan HL. You can grab this in the harness running just above the battery area. Just make strong connections.

X10134 you may need to run all the way to the CAS.

Thanks !