[citruzRD]

Hi everybody,

I am new in this forum but not in the BMW World, I have some question for you guys.

I starting a part time job as a BMW mechanic, I have some basic tools to make basics works but the most important service that I offer is to scan BMWs:

For example when people are going to buy a used BMW I make a pre purchase car inspection with block tester, compression gauge and the software.

I have,

- ISTA
- Inpa 5.0.2
- EDIABAS 7.3.0
- NCS Expert
- NCS Dummy
- Tool32
- WinKFP
- SP-DATEN v60
- BMW Coding Tool v2.5.0
- K+dcan cable
- ENET cable for F series
- BMW SCANNER 1.4

1-What other software do I need?

2-Does exist a software that you can have all the modules in a list and in the same display you can see if every module belong to the VIN car?

3-Why after I updated to SP daten files v60 after scan the car with INPA errors showed in german.

4- What is the latest version of SP daten file in english?

5- What else you can recommended to me in this bussiness?

Common BMW's that I going to work, are e39,e53,e46,e60,e70,e82,e90,e92, you know cars that aren't too new.

I hope some one can advise me because I was afraid of make this thread.