Checklist for Guibo Replacement

downshiftdata · 10-31-2018, 08:49 AM

I have a 2006 330xi (E90). The front driveshaft was damaged near the transfer case, and I had a shop replace it. They replaced the driveshaft, but not the guibo or any other parts closer to the transfer case. After I got it back, I found that the transfer case was leaking. Last night, I drained and refilled the transfer case, hoping that maybe it was the drain plug o-ring and knowing from the drip that the fluid was in bad need of replacement anyway.

Well, that's not it. I'm guessing I need to do what I should've done all along, which is replace the guibo, etc, and especially the seal (https://www.ecstuning.com/b-corteco-...107546667~cor/).

I'm looking for advice, links to good YouTube vids, suggestions on parts I might forget to order, etc, before I tackle this. Thanks for any help.

downshiftdata · 10-31-2018, 10:47 AM

Leaving this here for myself and anyone else who needs it:

https://www.e90post.com/forums/showthread.php?t=1220395

nsjames · 10-31-2018, 05:37 PM

how was your driveshaft damaged?

quite possible the front output bearing got wasted.
make sure you check it for slop when you're replacing the seal. Doing the bearing now will be a whole lot cheaper than replacing the case.

downshiftdata · 11-03-2018, 02:37 PM

The "knuckle" on the transfer case end of it failed, started twisting on itself.

And I looked at the diagram wrong - there's no guibo on the front shaft, only on the rear. But now that I've been under there a couple of times, it's become more clear that it's likely the output shaft seal that's leaking.

My problem right now is that I can't get the output shaft out so that I can replace the seal. See https://www.e90post.com/forums/showthread.php?t=1220395.

And thanks for the advice - I'll take a close look at it when I do get it off.

10-31-2018, 08:49 AM	#1
downshiftdata New Member 3 Rep 16 Posts Drives: '06 330xi Join Date: Jan 2018 Location: Indy iTrader: (0)	Checklist for Guibo Replacement I have a 2006 330xi (E90). The front driveshaft was damaged near the transfer case, and I had a shop replace it. They replaced the driveshaft, but not the guibo or any other parts closer to the transfer case. After I got it back, I found that the transfer case was leaking. Last night, I drained and refilled the transfer case, hoping that maybe it was the drain plug o-ring and knowing from the drip that the fluid was in bad need of replacement anyway. Well, that's not it. I'm guessing I need to do what I should've done all along, which is replace the guibo, etc, and especially the seal (https://www.ecstuning.com/b-corteco-...107546667~cor/). I'm looking for advice, links to good YouTube vids, suggestions on parts I might forget to order, etc, before I tackle this. Thanks for any help.
	Appreciate 0 Tweet Quote

10-31-2018, 10:47 AM	#2
downshiftdata New Member 3 Rep 16 Posts Drives: '06 330xi Join Date: Jan 2018 Location: Indy iTrader: (0)	Leaving this here for myself and anyone else who needs it: https://www.e90post.com/forums/showthread.php?t=1220395
	Appreciate 0 Quote

10-31-2018, 05:37 PM	#3
nsjames Brigadier General 2463 Rep 4,328 Posts Drives: 08 328xi Touring Join Date: May 2017 Location: ohio iTrader: (0)	how was your driveshaft damaged? quite possible the front output bearing got wasted. make sure you check it for slop when you're replacing the seal. Doing the bearing now will be a whole lot cheaper than replacing the case.
	Appreciate 0 Quote

11-03-2018, 02:37 PM	#4
downshiftdata New Member 3 Rep 16 Posts Drives: '06 330xi Join Date: Jan 2018 Location: Indy iTrader: (0)	The "knuckle" on the transfer case end of it failed, started twisting on itself. And I looked at the diagram wrong - there's no guibo on the front shaft, only on the rear. But now that I've been under there a couple of times, it's become more clear that it's likely the output shaft seal that's leaking. My problem right now is that I can't get the output shaft out so that I can replace the seal. See https://www.e90post.com/forums/showthread.php?t=1220395. And thanks for the advice - I'll take a close look at it when I do get it off.
	Appreciate 0 Quote