[bsad0521]

Has anyone ever had a leak from the oil pressure switch on the OFH. I just replaced my OFHG and OCHG. Maybe the switch is loose? not sure if I just tighten it down a little or buy a new one.

[Wolf 335]

Switch?

[bsad0521]

Originally Posted by Wolf 335

Switch?

sensor? Im not sure what its called lol

[Joebie]

Originally Posted by bsad0521

Has anyone ever had a leak from the oil pressure switch on the OFH. I just replaced my OFHG and OCHG. Maybe the switch is loose? not sure if I just tighten it down a little or buy a new one.

Tighten it and see if that works, if it doesnt, buy a new crush washer for it. I've never heard of this leaking though so are you sure it's leaking from there?

Originally Posted by Wolf 335

Switch?

The oil pressure switch on the OFH is just a switch, not an analog sensor. It only sends an on/off signal based on whether oil pressure is above or below a certain threshold. That's why if you look closely it's only got 1 wire coming out of it.

[bsad0521]

Originally Posted by Joester

Tighten it and see if that works, if it doesnt, buy a new crush washer for it. I've never heard of this leaking though so are you sure it's leaking from there?



The oil pressure switch on the OFH is just a switch, not an analog sensor. It only sends an on/off signal based on whether oil pressure is above or below a certain threshold. That's why if you look closely it's only got 1 wire coming out of it.

Thanks a ton. There's a tiny bit of oil right under it and all the seals where the gaskets lie are dry so I suspect the switch. Is there a torque spec for it?