NEW! N52 IAT Relocation Kit!

ECSTuning · 05-29-2019, 05:05 PM

All vehicles will lose some degree of performance due to heat soak under the right operating conditions. BMW integrated the intake air temp sensor in the MAF housing several models, including those powered by the N52. Compensating for this false hot air measurement, the ECU pulls timing and runs a richer fuel mixture, resulting in a significant loss of torque.

Turner designed an IAT relocation kit that moves the intake air temp sensor to a cooler location. The result is you’ll experience reduced torque loss and more consistent power output when you’re pushing your engine hard.

New Turner Motorsport N52 IAT Relocation Kit

For Your N52 Powered BMW

bluewater328 · 05-29-2019, 05:42 PM

Just wanted to clarify: Is what this kit does is bypass the portion of the MAF molex and instead gets a signal from a dedicated IAT which is positioned further up the airstream before the filter box?

Since I don't want to assume, based on your 4th picture in the link, it comes with a new dedicated IAT (with a nut and a gripped washer) that we would drill a hole for and secure from the inside of the inlet passage. The bypass cable single end would be plugged into the existing MAF harness and then the Y-split pieces would go to the current MAF (which stays in position) and IAT respectively?

05-29-2019, 05:05 PM	#1
ECSTuning New Lifetime Replacement Policy 832 Rep 11,738 Posts Drives: Independent Tuning Specialists Join Date: Jul 2008 Location: Ohio iTrader: (18)	NEW! N52 IAT Relocation Kit! All vehicles will lose some degree of performance due to heat soak under the right operating conditions. BMW integrated the intake air temp sensor in the MAF housing several models, including those powered by the N52. Compensating for this false hot air measurement, the ECU pulls timing and runs a richer fuel mixture, resulting in a significant loss of torque. Turner designed an IAT relocation kit that moves the intake air temp sensor to a cooler location. The result is you’ll experience reduced torque loss and more consistent power output when you’re pushing your engine hard. New Turner Motorsport N52 IAT Relocation Kit For Your N52 Powered BMW
	Appreciate 0 Tweet

05-29-2019, 05:42 PM	#2
bluewater328 Colonel 629 Rep 2,099 Posts Drives: 2011 bluewater 328i LCI sedan Join Date: Aug 2010 Location: Hawaii iTrader: (0)	Just wanted to clarify: Is what this kit does is bypass the portion of the MAF molex and instead gets a signal from a dedicated IAT which is positioned further up the airstream before the filter box? Since I don't want to assume, based on your 4th picture in the link, it comes with a new dedicated IAT (with a nut and a gripped washer) that we would drill a hole for and secure from the inside of the inlet passage. The bypass cable single end would be plugged into the existing MAF harness and then the Y-split pieces would go to the current MAF (which stays in position) and IAT respectively?
	Appreciate 0