[NCSUPack24]

So I'm trying to update my MSV80 DME with WinKFP in Comfort Mode (to help with rough idle issues) but WinKFP doesn't recognize my DME's UIF of 7625958. I've checked in the HWDR (sp?) and there's a few numbers close to it under the MSV80 section, but no dice. It looks like in other posts people have used the serial # to check/fix this? I pulled the DME and got the serial #: 12147576297 if that helps at all.

How do I fix this/is there another workaround? Usually I'm gung ho about experimenting with modules/trying things, but I haven't had this happen before, and I'm not trying to brick the DME.

Thanks!

[bluewater328]

Originally Posted by PGAHopeful26

So I'm trying to update my MSV80 DME with WinKFP in Comfort Mode (to help with rough idle issues) but WinKFP doesn't recognize my DME's UIF of 7625958. I've checked in the HWDR (sp?) and there's a few numbers close to it under the MSV80 section, but no dice. It looks like in other posts people have used the serial # to check/fix this? I pulled the DME and got the serial #: 12147576297 if that helps at all.

How do I fix this/is there another workaround? Usually I'm gung ho about experimenting with modules/trying things, but I haven't had this happen before, and I'm not trying to brick the DME.

Thanks!

Did you open INPA and check for your actual value? You should go the UIF (see attached) and look up the ZB# there to reference and input.

[sdbmwcoding]

Your ZB number 7625958 is for MSV80. Choose MSV80 and prog zb update and winkfp will automatically choose the correct update.

[NCSUPack24]

Originally Posted by bluewater328

Did you open INPA and check for your actual value? You should go the UIF (see attached) and look up the ZB# there to reference and input.

Yep, here's INPA's UIF page.

[NCSUPack24]

Originally Posted by sd*********

Your ZB number 7625958 is for MSV80. Choose MSV80 and prog zb update and winkfp will automatically choose the correct update.

Alright, I'll give that a go, thanks for confirming. Roughly long does it take to flash the DME? Just making sure I have adequate power around.