[Kony]

Hello,

I have e92 325d 03/2009 with CIC. I changed my interior, had non-sport cloth front seats, no memory, no heated, but half of moving was electric and half manual (2 buttons on side of each seat).

Now I have alcantara interior, front seats only manual but with heat and that button what tighten your sides of seats. Also have new panel with heated seat buttons. But when we just did plug'n'play, nothing works.

I have some diagram to switch pins. That work will do mechanic, coz I'm not friend with electric.

But I'm passive user of ista+/inpa and have NCS too. I found on this forum tutorial:

1.In NCS Expert, load the Expertmode profile.

2.Press F1 or the VIN/ZCS/FA button.

3.Press F3 or the ZCS/FA f. ECU button.

4.In the Choose CHASSIS pop-up window, choose the E89 chassis and press the OK button.

5.In the Choose ECU pop-up window, choose the CAS ECU and press the OK button.

6.The model (CHASSIS), VIN number (FG), and VO (FA) should be displayed in NCS Expert.

7.Press F2 or the Enter FA button to modify the VO.

8.In the Choose CHASSIS pop-up window, choose the E89 chassis and press the OK button.

9.In the Enter VIN pop-up window, verify that the Vin listed is the correct VIN number for the vehicle. The last digit attached to the VIN number is a checksum. You should not have to change anything on this step. Just verify and press the OK button.

10.In the Enter FA pop-up screen, for the Attribute text field, input the SA or Service Code. After typing in the code, press the Add button, and verify that the code was listed in the list of FA codes. After verifying, press the OK button.

-SA codes will begin with a “$”
-Service Codes will begin with a “+”

11.Press F6 or the Back button.

12.Press F4 or Process ECU button.

13.For the Choose ECU pop-up window, select CAS and press the OK button.

14.Press F2 or the Change job button.

15.From the Choose job pop-up window, select FA_WRITE and press the OK button.

16.Under “get coded:”, verify that CAS is the ECU selected to get coded. Also verify the JOBNAME is equal to FA_WRITE, and then press F3 or the Execute job button.

But also found someone saying that you need to code IHKA, JBBF, SMFA, SMBF or even CIC too. So should I do the same FA_WRITE and Execute job for CAS, NFRM, IHKA, JBBF and CIC? Is FA_WRITE enough, or I need to do also CODIERDATE_LESEN, change something to aktiv (nicht_aktiv) and SG_CODIEREN it?

Also I found on forum that when I have coded heated seats to the car and if I try to turn on them on panel, light above button will light for 5 sec and then turn off, is that true? It will be nice test if I code it correctly.

Sorry for my bad english and thanks to everyone who will try to help me.

[dj_aivan]

I will try to help. I made this retrofit, I attached the file, I made mine on it and everything works great.
You need to add $ 494 to the Cas and FRM with Fa_write and code JBBL and INKA

https://www.e90post.com/forums/showthread.php?t=229396