[Olo7109]

LOL I'm reaching out for some hopeful help. yesterday I drove my 2007 328xi without issue then parked and took off one rim after the other to put spacers on the wheels. went on all good, rims all reinstalled nicely. bolts were correct length, sat the car down and went to start for a test drive to make sure no vibration was present.
tried starting and it will crank but not start. so start trying to figure out where I had gone wrong.
first UNINSTALLED the spacers. still the same. I didn't suspect them but they were last thing touched since the car was running fine earlier in the day.
second disconnected negative on battery for 15 minutes. same result. crank, no start.
4x4, abs,. ccid 24, 351 and 354.
next we plugged in Carly and pulled error codes from everything. here are some screen shots of the codes (I know my steering wheel buttons are inactive, they always have been. my phone sos error is always present but everything else is pretty much beyond me at this point. I also included a list of everything done to this car that I have since August of last year. I know the timing water pump and t-stat were done at 79k, (104377 right now)

also tested for electric water pump to come on, it worked fine when activated.

battery reads 11.7-11.8 on accessory mode.

my wife thinks it's some kind of special shut down mode to avoid a worse problem that it feels like might happen if it does run and move.

after reading and looking and searching: I unplugged mas and still same result, crank no start.
checked ground straps


help? checking fuses now, none seem to be blown as of yet. still going in there though.


so the screenshots look a little crazy. copy&pasted it all here:
Fault memory

009520
Description:
Steering wheel MFL mechanically defective, contact audio/telephone button for t 5 min operated (DSC switch cluster steering column: multifunction)/ Steering wheel MFL mechanically defective contact/SSL error entry for SSL LWS error audio/telephone switch: mechanical problem, contact


005E22
Description:
Wheel speed front left leitungs fault or short circult / Coll inlet valve (150), rear left temperature exceeded / Pressure sensor rear control circuit implausible


005E24
Description:
Wheel speed front left signal edge is missing (RDF type 110. / Pressure sensor 1 implausible / Whee speed front left signal edge is missing (DF11)./ Wheel speed front left signal edge is missing, RDF type 11 (DSC wheel speed supply front left) /Pressure sensor 1/2 implausible/Coil outlet valve (dump) the front left temperature exceeded/Pressure sensor front control circuit implausible


005E4C
Description:
Pressure sensor sensor error gain/Wheel speed sensor front right lestungs fault or short circuit

005EBA
Description:
Steering angle sensor steering angle signal only relativ rad center position unbekanntlemquadrant activer (to stop directing) OR LW signal invalid, OR LW state enor/Stearing angle sensor: status error / Steering angle sensor steering angle signal only relativ rad center position unbekannt lernquadrant active (to stop directing) ORLW signal invalid OR LW-state error (DSC steering angle sensor plausibaity) Steering angle sensor status error/Steering angle sensor status error steering angle signal invalid or steering angle signal only relative center position unknown. leaming quadrant active directing the stop


005F77
Description:
DME fault DME transmits torque value Invalid (PT-CAN, ID DAB signal ST RCPT ENG DSC). / DME error status torque current value is invalid (ID 0x0A (ST RCPT ENG DSC))/ DME fault DME sends forque value invalidt PT-CAN, OxA8 ID, ST signal TORQ AVL (DSC motor control interface)

Potential consequences:
o Power reduction and/or speed limitation running)
is or may be activated (emergency operation/emergency
there is a risk of (further) malfunctions o further errors (consequential errors) are possible

Car Access System
Fault memory

00A0B4
Description:
Error engine start starter operation A0B4
React immediately

00A10A
Description:
EWS4 timing chall resp error

002E85
Description:
Electric coolant pump, communication

Potential consequences:
Following components malfunctions are possible

O Engine output/power delivery may be limited
o there is a risk of (further) malfunctions
o further errors (consequential errors) are possible
Engine could be damaged in case of overheating O knocking of the motor can be caused at high speed/load

Othere is a risk of (further) malfunctions
o further errors (consequential errors) are possible


002ACC
Description:
DME main relay, switching delay
Potential consequences:
Power reduction and/or speed limitation is or may be activated. (emergency running)
o there is a risk of (further) malfunctions
o further errors (consequential errors) are possible


002ACB
Description:
DME main relay contral
Potential consequences:
Power reduction and/or speed limitation is or may be activated, (emergency operation/emergency running)
Othere is a risk of (further) malfunctions
o further errors (consequential errors) are possible


00A559
Description:
Terminal 30g f shutdown/ KL 30g f shutdown/Terminal 30g f cutoff
Not serious

00A554
Description:
Alive error phone/Live phone
More information:[IMG]undefined[/IMG]

[e91Owner]

The screenshots (at least when I look at them) are illegible. The speed sensor errors are likely due to the spacer issue since it is flagging all of them. I've had them go bad and they produce similar errors, although they did not cause the car not to start. Did you clear the errors after removing the spacers?

2E85 would be fixed with a new water pump. Had that same error on my e60 for years without it failing and finally replaced it a few months ago. No more 2E85. Might have lasted years more or only days, but I'll never know.

[Elianne205]

Where you able to fix this error?
00A10A
Description:
EWS4 timing chall resp error
I have the same issue, my car crank but don’t start