[MVested]

anybody? DPs are hanging but wont budge. anybody?? remember for xi

[jpsimon]

either cut them in half and pull them out (catless aftermarket downpipes fit back in without issues)

or...

Originally Posted by ar design

We did however have to remove the passenger side axle and axle bearing cage.

[ar design]

I don't think aftermarket pipes will go back in without pulling the axle and bearing cage. Its not *too* hard if you know what you're doing. If you need some pointers feel free to give me a call, I will help as best I can!

[jpsimon]

Originally Posted by ar design

I don't think aftermarket pipes will go back in without pulling the axle and bearing cage. Its not *too* hard if you know what you're doing. If you need some pointers feel free to give me a call, I will help as best I can!

My UR downpipes went back in without pulling the axle and bearing cage

[ar design]

Originally Posted by jpsimon

My UR downpipes went back in without pulling the axle and bearing cage

I haven't installed URs. They are 2.5" all the way. Ours are 3" for about 1/2 of the pipe.

[NatesGr8]

for jp's we removed the motor mount that's next to the dp's to get the new ones back in.

ar when removing the axle and bearing cage did you need to drain any tranny fluid? i think i asked you this in another post but not sure if you answered or not.

edit: jp's are 2.5" the whole way

Thanks, Nate

[ar design]

Originally Posted by NatesGr8

for jp's we removed the motor mount that's next to the dp's to get the new ones back in.

ar when removing the axle and bearing cage did you need to drain any tranny fluid? i think i asked you this in another post but not sure if you answered or not.

edit: jp's are 2.5" the whole way

Thanks, Nate

Nope, just lost a few oz.