[carloperatoner]

I just installed the factory alarm system in my 09-335i. It works really well after coding. I do have one interesting issue that I have not been able to resolve. When I lock the car, I get the double chirp and the lights flash. When I unlock, I only get the single chirp and the lights do not flash.

My car does not have I-drive and I have changed the settings in both the DWAI module as well as from the stalk. Here is a copy of my DWAI settings. Any thoughts would be welcome.

CODIERUNG_ERFOLGT
codierung_erfolgt
CODIERUNG_ERFOLGT_1
codierung_erfolgt
LAUTSTAERKE
aktiv
TIMEOUT_DEAKT_IRNE
wert_10
ALARM_OPT_WARNBLINKER
aktiv
PARAMETER_IRS
wert_08
QUIT_OPT_SCHAERF
nicht_aktiv
NOTLAUFFUNKTION_HUPE
nicht_aktiv
HOTELSTELLUNG
nicht_aktiv
QUIT_AKUST_SCHAERF
aktiv
NEIGUNGSGEBER
aktiv
FUNK_INNENRAUMSCHUTZ
aktiv
QUIT_OPT_SCHAERF_KLAPPE
aktiv
QUIT_OPT_ENTSCH
aktiv
TRIGGERANZAHL_KLAPPEN
wert_01
TRIGGERANZAHL_SENSOREN
wert_01
ALARM_OPT_FERNLICHT
aktiv
QUIT_AKUST_SCHAERF_KLAPPE
aktiv
PANIK_ALARM
aktiv
QUIT_AKUST_ENTSCH
aktiv
LADEEINRICHTUNG
nicht_aktiv
MOTORFERNSTART
nicht_aktiv
SCHIEBEHEBEDACH
aktiv
DEF_QUIT_AKUST_ENTSCH
aktiv
DEF_QUIT_OPT_ENTSCH
aktiv
DEF_QUIT_AKUST_SCHAERF
aktiv
DEF_QUIT_AKUST_SCHAERF_KL
aktiv
DEF_QUIT_OPT_SCHAERF
aktiv
DEF_QUIT_OPT_SCHAERF_KLAP
aktiv
ANFRAGE_FENSTERPOSITIONEN
aktiv
PIAU_AKUST_ENTSCH
aktiv
PIAU_AKUST_SCHAERF_KLAPPE
aktiv
SIGNAL_HK
aktiv

Thanks in advance

[e90yyc]

I would suggest downloading NCS Dummy if you don’t already have it. It provides in-app translations for all of the most common functions.

The way it works is you pull your trace file using NCS Expert, load it into NCS Dummy, make your changes in the app, export/save the modified trace file, and then use NCS Dummy to write it back to the module.

Someone might have a quick answer for you on this, but I also suspect you’ll be able to find the offending value if you load your trace file into NCS Dummy.