[CRn54]

Hey guys, so I’m trying to pull my engine and this is my first time pulling an n54 out. I’ve watched a few videos to get an understanding on what to do, and what to remove/disconnect. I’ve removed and disconnected everything, I’ve got all the bolts out of the bell housing I have separation from the transmission but can’t seem to get it all the way separated. Could there be anything I’m missing. Any suggestions would be greatly appreciated

[arunedmunds]

You’ve said you have watched some videos so that’s a good start.

Not much to go off of so here’s a little checklist

- torque converter bolts
- driveshaft to guibo is properly disconnected and out of the way
- transmission lines are not catching
- trans brace is not connected still

I know it may seem like stupid points but you never know

Use a Prybar and gently wiggle it between the bell housing and block, it may just need a little negotiation

Also try to adjust the jack height and position too.