[original786]

hey guys i need your opinion and your suggestions..

so i am thinking of buying vishnu procede canbus. it is used in good condition and comes with all the wiring and remote

since im a novice at this stuff..

1. how hard is it to install my self?

2. do i need to buy a boost gauge or i am fine without it

3. i dont want to void my warranty, how do i de code it when i take the chip out to take it to dealership so they wont see it in the system.

4. what stage is good to run on if i have just exhaust and sr mid pipe?

5. what should be my power gains like?

6. if i get an intake will that help gain since im getting chip?

7. is this a good chip to start off with, and later what is a good upgrade or add on to this unit?

8. and for who had this canbus are you guys satisfied?


Thank you guys

[RiXst3r]

Originally Posted by original786

hey guys i need your opinion and your suggestions..

so i am thinking of buying vishnu procede canbus. it is used in good condition and comes with all the wiring and remote

since im a novice at this stuff..

1. how hard is it to install my self?

Not too bad, this should help... we wrote a little mini-guide for what to do right after purchasing the unit: http://www.p3cars.com/2009/07/suppor...ducts-procede/

Originally Posted by original786

2. do i need to buy a boost gauge or i am fine without it

We suggest one, but its not a must... once you have it though, you will wonder how you ever did without it... its so easy to see exactly what your car is boosting, know exactly what boost map you are in, etc.

Originally Posted by original786

3. i dont want to void my warranty, how do i de code it when i take the chip out to take it to dealership so they wont see it in the system.

There is a process that only the PROcede does that clears all engine codes. You turn on the ignition, hold the pedal to the floor for a few seconds, then release, a check engine light will appear, do this again, and all codes are cleaer. Uninstall the unit and its like nothing was ever there!

Originally Posted by original786

4. what stage is good to run on if i have just exhaust and sr mid pipe?

Stage 1 would be a good place to start, recommended.

Originally Posted by original786

5. what should be my power gains like?

60-90whp depending on gas, mods, weather, and maps.

Originally Posted by original786

6. if i get an intake will that help gain since im getting chip?

Yes, intakes are good for any tune running higher boost, as this becomes a choke point.

Originally Posted by original786

7. is this a good chip to start off with, and later what is a good upgrade or add on to this unit?

FMIC would be a great next step.

Originally Posted by original786

8. and for who had this canbus are you guys satisfied?

We love it!

Feel free to contact us.

We sell the PROcede canbus unit, the #1 335 boost gauge, as well as Vishnu intakes in our store at www.p3cars.com

Combo deals are always possible

-Rick

[original786]

thanks