[Shifty]

I was doing a pull last night and something went wrong...

The diverter valves join a wider piping, this then leads to a metal thing (?), well it is at this joining where it came loose. I have joined them again but it still seems loose, how does it hold in place?

[JoeyFiasco]

after you rejoined it, is it leaking or just loose?

[cn555ic]

It's held on by a C-clip. Need to pull that clip up a little and make sure that pipe gets pushed up and then snap the clip back down

[Shifty]

Originally Posted by cn555ic

It's held on by a C-clip. Need to pull that clip up a little and make sure that pipe gets pushed up and then snap the clip back down

Just did that and it works...question is...will it happen again? :/

[cn555ic]

Originally Posted by Shifty

Just did that and it works...question is...will it happen again? :/

Yes it will unless you take out that pipe and really clean off the oil residue....It needs to be 100% clean of oil on the attachment between the throttle body and the charge pipe...After you clean it out re-attach the connection and get yourself a oil catch can to help eliminate this from happening...