[supradriver]

I am finally getting a chance to hook my methanol up with my Procede and had a few questions. I have all of the Labonte electronics so that is not the issue. I had a few questions regarding a dual nozzle setup. The meth line that come directly from the controller do I split the line before the solenoid or after the solenoid? So, in essence one line would go directly to my first nozzle and the second line that has been split would go to the solenoid and then to the second nozzle. If I split it after the solenoid won't both of them be spraying at the same time? The purpose of the second nozzle is strictly for nitrous if I understand what Shiv said correctly. Any help would be greatly appreciated.

[R1000K3]

The best solution is to split after the pump and use another solenoid for the N2O meth support nozzle, which opens directly when nitrous is engaged independent of the Labonte controller. Just my 2c.

[OpenFlash]

Originally Posted by R1000K3

The best solution is to split after the pump and use another solenoid for the N2O meth support nozzle, which opens directly when nitrous is engaged independent of the Labonte controller. Just my 2c.

+1
I just talked to the OP on the phone btw.

[supradriver]

Originally Posted by shiv@vishnu

+1
I just talked to the OP on the phone btw.

Thanks for the quick response and your help Shiv! I should have everything back together today to test out the new autotune methanol maps.