[Funkmob]

Guys,

Im running a Labonte S4 meth injection setup , it injects according to boost and injector duty cycle.
When i log my debug byte 7 i see a flow of 0.8 to 0.9 on my procede datalog.
So this should be 800 to 900ml/min.
Now i see others have a value of around 14 on a M7 nozlle. Does this mean they are flowing 1400ml/min on a M7 nozlle? I'm running a M10 btw.

Isn't 700/800ml/min enough for a full modded stage 4 running 17.5psi on pump and meth?

thanks.

[cn555ic]

Originally Posted by Funkmob

Guys,

Im running a Labonte S4 meth injection setup , it injects according to boost and injector duty cycle.
When i log my debug byte 7 i see a flow of 0.8 to 0.9 on my procede datalog.
So this should be 800 to 900ml/min.
Now i see others have a value of around 14 on a M7 nozlle. Does this mean they are flowing 1400ml/min on a M7 nozlle? I'm running a M10 btw.

Isn't 700/800ml/min enough for a full modded stage 4 running 17.5psi on pump and meth?

thanks.

load up the newest software and make sure you drop into the reader the current files into the reader and replace the old channels files....It seems as though your using the old channel variables

[OpenFlash]

Originally Posted by cn555ic

load up the newest software and make sure you drop into the reader the current files into the reader and replace the old channels files....It seems as though your using the old channel variables

+1. Looks like debug byte 7 is displaying in voltage, not in % (of 5v). As mentioned, just drop the datalog setup files included with the current maps in your foldered names "Procede" and you'll be fine.

Fwiw, voltage of .9 equates to 18% (.5/5) which is just about right for an m10 nozzle.

[Funkmob]

Sorry , i made a mistake . Its showing 8.0 to 9.0 , so maybe still on the low side?

On my digital controller i see a peak injection of around 550ml/min.
In the datalog it changes from 8.0 to 9.0 .

The thing is im trying to set up my progressive meth control.
If i just run map2 at UT70 and IC0 the car is really fast , also under light throtlle or medium throtlle.

When i change to progressive meth map , the car becomes alot slower.
Probably due to running in map 1 until meth flows.

I set the injection mode to 8 , but when i run in progressive meth map and i go full throlle , it almost takes 2 seconds to see the hazard lights light up and feel the mapping change.

I start injecting around 6-7 psi and on my meth controller im clearly flowing before i see my hazard lights detect flow.

Can someone also explain me how i can post a datalog view here?

Originally Posted by shiv@vishnu

+1. Looks like debug byte 7 is displaying in voltage, not in % (of 5v). As mentioned, just drop the datalog setup files included with the current maps in your foldered names "Procede" and you'll be fine.

Fwiw, voltage of .9 equates to 18% (.5/5) which is just about right for an m10 nozzle.