[rac1]

Hello all:

Did several searches and reviewed the results but I cannot seem to find the relevant information.

Recently purchased a 2007 328i with the headlight washers.

I am getting it clearbra'd all around and will be purchasing m tech side sills (which I think are subtle but fit the zsp better) and a new front bumper to be clearbra'd.

It appears that to delete the headlight washers, which I have already come to hate, you can either pull fuse 43, or disconnect the pump from the wiring harness under the passenger front wheel well. I will probably be doing the latter.

My question is since I am disabling the spritzers anyway, I would like the new front bumper I'm ordering for paint and film to be the non-cold weather bumper without cutouts (Part 51117140859).

Once I remove the covers, would this sit fine on the front end or would the pieces underneath the washer cover stick up a bit too much and get in the way?

I'd rather not have to fill or drill holes, so if I can put the non cutout front bumper right over the headlight washers and use an rho plate holder it would make my day

I'm ordering the parts from Tischer today and getting everything installed in the next couple weeks among other goodies-coming from an old maxima, this thing rocks!

Thanks for your help guys!