[drewmeyer87]

SOLVED: Post Here

Hey guys,

I have checked all of the obvious items, my filter in the WW Tank was sparkley clean, no gunk whatsoever. My Check Valve seems to be working properly as well, can't blow any air through it.

I'm getting 2-3 seconds of meth flow each time I go WOT and then the indicators cut out.

Anyone know what else I can check?

[The Ghost]

I'd check all of the connections including those around in the in-line filter, which can come loose.

What type of meth system do you have?

[Jeff@TopGearSolutions]

What is your meth flow ouput and what are your settings. Logs? Air in the lines?

[Joshboody]

Logs man, logs... otherwise cannot help. I believe you have Vishnu PWM kit, so log:
both throttles
Meth flow and injection %
boost

[cwn23]

Originally Posted by drewmeyer87

Hey guys,

I have checked all of the obvious items, my filter in the WW Tank was sparkley clean, no gunk whatsoever. My Check Valve seems to be working properly as well, can't blow any air through it.

I'm getting 2-3 seconds of meth flow each time I go WOT and then the indicators cut out.

Anyone know what else I can check?

Goto the Procede user software and under the adjustables look for the parameters of meth flow %...I would try lowering the number by a couple for instance if its like 18 lower it to 15 and then try to see if meth lights stay on...

[drewmeyer87]

All 3rd gear pulls

With WW Sprayers Held down:


Without sprayers held #1


Without sprayers held #2


Without sprayers held #3

[drewmeyer87]

Originally Posted by cwn23

Goto the Procede user software and under the adjustables look for the parameters of meth flow %...I would try lowering the number by a couple for instance if its like 18 lower it to 15 and then try to see if meth lights stay on...

Injection mode? It's set to 20%, based on the install instructions.

[drewmeyer87]

Oh... I should have probably note I modified the Meth Injector DC Table values to 100 on all loads equal to and over 153 to test if that would remedy any of my issues.

Also, the flow adjustement nut on the pump is screwed all the way in for max flow.

[OpenFlash]

Originally Posted by drewmeyer87

Oh... I should have probably note I modified the Meth Injector DC Table values to 100 on all loads equal to and over 153 to test if that would remedy any of my issues.

Also, the flow adjustement nut on the pump is screwed all the way in for max flow.

I think you are barking up the wrong tree. You have email

[drewmeyer87]

FIXED!

Worked with Shiv to troubleshoot. Thanks for pointing me in the right direction.

After checking all my fittings, I removed the WW washer line T-Tap and replaced it with a straight fitting. Still had issues. Removed all fitting everywhere and trimmed up my lines with a razor blade to ensure clean cuts. Re-tightened and seated all connections. One thing that may have been a tad loose was the Aquamist In-line filter... make sure its not just hand tightened, grab some pliers and tighten those bad boys good and tight!

Logs:

[Jeff@TopGearSolutions]

99% of meth problems stem from leaks. Its best to just run through the entire system when troubleshooting, retighten, add teflon paste, check for clogs, clean up lines ETC. Glad you got it fixed.