[HellFire335]

while following the diy in the coding success thread i found there are no option for PORT in my device manager, i've got three usb plugs and the k+dcan obd adapter is usb but no connection, the set up im using is an IMB x60 running xp tablet edition

[cn555ic]

Plug the cable in and install the drivers. Pull cable out and then look at device manager and the plug cable in again. Find out where the cable is on the device manager and find it and reinstall the drivers again and it should now show dcan cable

[HellFire335]

you rock, that fixed it and now it connects but i keep getting an error now when i try to read a module like the airbag that says
"ApiCheckJobSatus: Error #13
IFH-0003: datatransmission to interface disturbed
api job error or no such result"

[cn555ic]

Originally Posted by HellFire335

you rock, that fixed it and now it connects but i keep getting an error now when i try to read a module like the airbag that says
"ApiCheckJobSatus: Error #13
IFH-0003: datatransmission to interface disturbed
api job error or no such result"

You need to goto into the Device manager and click on the dcan device and then you have to goto comports and then under advance turn the latency to 1 and you should be good...

[HellFire335]

that did not work, still have the same error

[cn555ic]

Originally Posted by HellFire335

that did not work, still have the same error

Alot of people get errors reading the airbag..Screw it and try to see if it reads the DME...If you have a N55 your out of luck because INPA has not been updated for the N55 and you would need to get ISTA-D...Good luck,

[HellFire335]

yup reads the dme, now if only i could read german lol

[cn555ic]

Originally Posted by HellFire335

yup reads the dme, now if only i could read german lol

Then dont worry about the Airbag as alot of people cant get that to read right...You made connection so thats what this thread is about..

[HellFire335]

yes thanks so much for the help